Cabletron Systems 9F106-01 Fpim Speciﬁcations, Parameter Typical Value Worst Worst Case Budget

Page 24

Appendix A

FPIM Speciﬁcations

This MMAC-Plus module uses Fiber Port Interface Modules (FPIM) to provide front panel cable connections. The FPIMs are user-installable. See the section titled Installing an FPIM on page 2-6.

FPIM-00

The FPIM-00 has a MIC style connector supporting a multimode ﬁber connection. The speciﬁcations are listed in Table A-1.

Table A-1. FPIM-00 Speciﬁcations

	Parameter	Typical Value	Worst	Worst Case	Typical
	Parameter	Typical Value	Case	Budget	Budget
			Case	Budget	Budget


	Receive	-30.5 dBm	-28.0 dBm	—	—
	Sensitivity

	Peak Input	-7.6 dBm	-8.2 dBm	—	—
	Power

A-1

Image 24

Contents MMAC-Plus9F106-01 Two Port Fddi Router User’s Guide Page FCC Notice Vcci NoticeDOC Notice Contents Features IntroductionManagement Information Base MIB Support Features Related Manuals Getting HelpInstalling the MMAC-Plus Module Installing the MMAC-Plus Module Reset Switch Local Management ConsoleMenu Function Selection XoffLocal Management Console Installing an Fpim Installing an FpimF106-01 Block Diagram OperationSystem Diagnostic Controller Flexible Network Bus FNBSystem Management Buses DC/DC ConverterFNB Interface CPULanview LEDs Lanview LEDsLED Color State Description LED Color StateFunction of the Fddi Receive LED is listed in Table Safety ServiceSpeciﬁcations Physical EnvironmentFpim Speciﬁcations Parameter Typical Value Worst Worst Case BudgetFPIM-02 and FPIM-04 Pin Number RepresentsFPIM-05 Parameter Typical Minimum Maximum