Cabletron Systems 9F106-01 manual FPIM-05, Parameter Typical Minimum Maximum

Page 26

FPIM-05

FPIM-05

The FPIM-05 has a MIC style connector supporting a Single-mode ﬁber connection. The speciﬁcations are listed in Table A-4.

Table A-4. FPIM-05 Speciﬁcations

Parameter	Typical	Minimum	Maximum


Transmitter Peak Wave	1300 nm	1270 nm	1330 nm
Length

Spectral Width	60 nm	-	100 nm

Rise Time	3.0 nsec	2.7 nsec	5.0 nsec

Fall Time	2.5 nsec	2.2 nsec	5.0 nsec

Duty Cycle	50.1%	49.6%	50.7%

Bit Error Rate	Better than 10-10

The link distance is up to 40 kilometers (max) and 25 kilometers (typical) on single mode ﬁber-optic cable as speciﬁed by ANSI SMF-PMD.

A-3

Image 26

Contents MMAC-Plus9F106-01 Two Port Fddi Router User’s Guide Page FCC Notice Vcci NoticeDOC Notice Contents Features IntroductionManagement Information Base MIB Support Features Related Manuals Getting HelpInstalling the MMAC-Plus Module Installing the MMAC-Plus Module Reset Switch Local Management ConsoleMenu Function Selection XoffLocal Management Console Installing an Fpim Installing an FpimF106-01 Block Diagram OperationSystem Management Buses System Diagnostic ControllerFlexible Network Bus FNB DC/DC ConverterFNB Interface CPULanview LEDs Lanview LEDsLED Color State Description LED Color StateFunction of the Fddi Receive LED is listed in Table Speciﬁcations SafetyService Physical EnvironmentFpim Speciﬁcations Parameter Typical Value Worst Worst Case BudgetFPIM-02 and FPIM-04 Pin Number RepresentsFPIM-05 Parameter Typical Minimum Maximum