Cabletron Systems 9F106-01 manual Management Information Base MIB Support

Page 7

Introduction

NOTE

Management Information Base (MIB) Support

The 9F106-01 module provides MIB support including the following:

•IETF FDDI MIB

•IETF MIB II

For a complete list of supported MIBs, refer to the release notes provided in the module package.

LANVIEW LEDs

The 9F106-01 uses LANVIEW: the Cabletron Systems built-in visual diagnostic and status monitoring system. With LANVIEW LEDs, you can quickly identify the device, port, and physical layer status at a glance.

Hot Swapping

The 9F106-01 can be installed or removed from the chassis while the MMAC-Plus is powered up without affecting the operation of the remaining modules in the chassis.

1-2

Image 7

Contents MMAC-Plus9F106-01 Two Port Fddi Router User’s Guide Page Vcci Notice FCC NoticeDOC Notice Contents Introduction FeaturesManagement Information Base MIB Support Features Getting Help Related ManualsInstalling the MMAC-Plus Module Installing the MMAC-Plus Module Local Management Console Reset SwitchXoff Menu Function SelectionLocal Management Console Installing an Fpim Installing an FpimOperation F106-01 Block DiagramDC/DC Converter System Diagnostic ControllerFlexible Network Bus FNB System Management BusesCPU FNB InterfaceLanview LEDs Lanview LEDsLED Color State LED Color State DescriptionFunction of the Fddi Receive LED is listed in Table Service SafetySpeciﬁcations Environment PhysicalParameter Typical Value Worst Worst Case Budget Fpim SpeciﬁcationsPin Number Represents FPIM-02 and FPIM-04Parameter Typical Minimum Maximum FPIM-05