Cabletron Systems 9F106-01 manual

Page 2

Notice

Notice

Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

© Copyright August 1995 by:

Cabletron Systems, Inc.

35 Industrial Way

Rochester, NH 03867-5005

All Rights Reserved

Printed in the United States of America

Order Number: 9031521 Aug 1995

MMAC-Plusis a trademark of Cabletron Systems, Inc.

Cisco Systems is a trademark of Cisco Systems, Inc.

CompuServe is a registered trademark of CompuServe, Inc.

i

Page 1 Page 3
Image 2
Page 1 Page 3
Contents MMAC-Plus9F106-01 Two Port Fddi Router User’s Guide Page FCC Notice Vcci NoticeDOC Notice Contents Features IntroductionManagement Information Base MIB Support Features Related Manuals Getting HelpInstalling the MMAC-Plus Module Installing the MMAC-Plus Module Reset Switch Local Management ConsoleMenu Function Selection XoffLocal Management Console Installing an Fpim Installing an FpimF106-01 Block Diagram OperationSystem Management Buses System Diagnostic ControllerFlexible Network Bus FNB DC/DC ConverterFNB Interface CPULanview LEDs Lanview LEDsLED Color State Description LED Color StateFunction of the Fddi Receive LED is listed in Table Specifications SafetyService Physical EnvironmentFpim Specifications Parameter Typical Value Worst Worst Case BudgetFPIM-02 and FPIM-04 Pin Number RepresentsFPIM-05 Parameter Typical Minimum Maximum
Top Page Image Contents