Cabletron Systems 9F106-01 manual Reset Switch, Local Management Console

Page 12

The Reset Switch

The Reset Switch

The Reset switch is located on the front panel, under the top plastic tab, as shown in Figure 2-2.It serves two functions:

Pressing the Reset switch twice within three seconds causes the processor to reset.

Pressing and holding the switch on for three or more seconds causes the module to shutdown. Pressing and holding again for three seconds restarts the module.

SNMP management may be used to disable this switch to enhance module security.

Reset Switch

Figure 2-2. The Reset Switch

Local Management Console

Local Management is accessed by attaching a management console at the RJ-45 CON port of the 9F106-01. The console connection supports a Digital Equipment Corporation VT 320™ terminal or PC emulation of one of these terminals.

Table 2-1lists the setup requirements for the local management console. If your terminal is a Digital Equipment Corporation VT 320™ terminal, press F3 to access the Setup Directory. If you have a terminal emulation of the Digital Equipment terminals, refer to your equipment user manual for setup procedures.

2-3

Image 12
Contents MMAC-Plus9F106-01 Two Port Fddi Router User’s Guide Page FCC Notice Vcci NoticeDOC Notice Contents Features IntroductionManagement Information Base MIB Support Features Related Manuals Getting HelpInstalling the MMAC-Plus Module Installing the MMAC-Plus Module Reset Switch Local Management ConsoleMenu Function Selection XoffLocal Management Console Installing an Fpim Installing an FpimF106-01 Block Diagram OperationSystem Diagnostic Controller Flexible Network Bus FNBSystem Management Buses DC/DC ConverterFNB Interface CPULanview LEDs Lanview LEDsLED Color State Description LED Color StateFunction of the Fddi Receive LED is listed in Table Safety ServiceSpecifications Physical EnvironmentFpim Specifications Parameter Typical Value Worst Worst Case BudgetFPIM-02 and FPIM-04 Pin Number RepresentsFPIM-05 Parameter Typical Minimum Maximum