TROUBLESHOOTING GUIDE
27
• GLASS “SOOT’S” UP AT A VERY FAST RATE
• FLAME IS LAZY, DARK, AND HAS BLACK TIPS
• AFTER STOVE HAS BEEN ON FOR A WHILE, THE BURNPOT OVERFILLS
Possible Causes: | Possible Remedies: | |
|
|
|
1. | Stove or vent pipe is dirty, which restricts airflow through the | Follow all cleaning procedure in the maintenance section of the |
| burnpot. | owner’s manual. |
|
|
|
2. | Vent pipe installed improperly. | Check to make sure the vent pipe has been installed according to |
|
| the criteria in the owner’s manual. |
|
|
|
3. | Air damper is set too far in (closed) for a higher setting. | Pull the damper knob farther out away from the side of the stove and |
|
| try to burn the unit again. |
|
|
|
4. | Burnpot holes are blocked. | Remove the burnpot and thoroughly clean it. |
|
|
|
5. | Air damper is broken. | Visually inspect the damper assembly. Make sure the damper plate |
|
| is attached to the damper rod. When the damper rod is moved the |
|
| plate should move with it. |
|
|
|
6. | Blockage in air intake pipe. | Visually inspect the air intake pipe that leads into the burnpot for |
|
| foreign material. |
|
|
|
7. | Circuit board malfunction. | Time the fuel feed light at each setting (after the stove has |
|
| completed the startup cycle). Make sure the times match the auger |
|
| timing chart. If the auger motor runs constantly, the board is bad. |
|
|
|
8. | Combustion blower is not spinning fast enough. | Test the RPM on the blower after the blades have been cleaned. |
|
| The RPM should be approximately 3000 RPM. |
|
|
|
9. | Bad Pellets | The brand of pellets or the batch of pellets that are being used may |
| (Applies to GLASS “SOOT’S” UP AT A VERY FAST RATE Only) | be of poor quality. If possible, try a different brand of pellets. You |
|
| might also want to try a brand that is made from a different type of |
|
| wood (softwood vs. hardwood). Different woods have different |
|
| characteristics when being burned. |
|
|
|
10. | The trim setting on the low feed rate is to low | Use the “Reset Trim” button to increase the low feed rate setting. If |
| (Applies to GLASS “SOOT’S” UP AT A VERY FAST RATE Only) | the 1 & 3 lights are on, the stove is currently on the lowest setting. If |
|
| only the 1 light is on, the stove is in the default (medium) setting. If |
|
| the 1 & 4 lights are on, the stove is in the high trim setting for the low |
|
| feed rate. If the stove is being burned on one of the two lower |
|
| settings, advance to the next trim setting and try burning the stove. |