Regency Wraps F38-LPG2, F38-NG2 installation manual Operating Instructions

Page 14

OPERATING INSTRUCTIONS

OPERATING

INSTRUCTIONS

Beforeoperatingthisappliance,proceedthrough the following check list.

1)Read and understand these Instructions before operating this appliance.

2)Check to see that all wiring is correct and enclosed to prevent possible shock.

3)Check to ensure there are no gas leaks.

4)Make sure the three pieces of door glass are properly positioned. Never operate the appliance with any of the glass removed or with the door open.

5)Verify that all fl ueing and the cap is unob- structed.

6)Verify log placement. If the pilot cannot be seen when lighting the unit - the logs or the embers have been incorrectly positioned.

7)The unit should never to turned off and on without a minimum of a 60 second wait.

LIGHTING

INSTRUCTIONS

IMPORTANT: The PILOT knob cannot be

turned from pilot to off unless it is partially

depressed.

Note: Open the pedestal door of the unit before lighting the pilot. Once the pilot is lit, close the door. You should never operate the unit with the door open.

1)If the PILOT knob is in the off position proceed to Step 4.

Diagram 1

2)Push in PILOT knob slightly and turn clock- wise to off. Knob cannot be turned from pilot to off unless knob is pushed in slightly. Do not force.

3)Wait five minutes to allow gas, that may have accumulated in the main burner compart- ment, to escape. If you smell gas, follow the instructions on the front of this manual. If you don't smell gas continue on to the next step.

4)Turn the PILOT knob counterclockwise to pilot and align it with the arrow as shown in diagram 1.

5)Push in PILOT knob all the way in and hold. Immediately push IGNITOR button until pilot lights. Continue to hold the PILOT knob in for approximately one minute, then release the PILOT knob. The pilot fl ame should continue to burn. If the pilot does not remain lit, repeat operation allowing a longer period before releasing PILOT knob.

6)Turn PILOT knob counter clockwise to on.

7)Use the ON/OFF switch to turn on the burner.

8)Rotate the HEAT control to adjust the fl ame height higher or lower.

SHUTDOWN

INSTRUCTIONS

1)Use the ON/OFF switch, wall switch, thermostat or remote control to turn off the burner.

2)Push in the PILOT knob slightly and turn clockwise to off. Do not force.

3)Turn off all electric power to the appliance if service is to be performed.

FIRST FIRE

The FIRST FIRE in your heater is part of the paint curing process. To ensure that the paint is properly cured, it is recommended that you burn your fi replace for at least four (4) hours the fi rst time you use it with the fan on.

When fi rst operated, the unit will release an odour caused by the curing of the paint and the burning off of any oils remaining from manufac- turing. Smoke detectors in the house may go off at this time. Open a few windows to ventilate the room for a couple of hours. The glass may require cleaning.

DO NOT ATTEMPT TO CLEAN THE GLASS WHILE IT IS STILL HOT!

Note: When the glass is cold and the appli- ance is lit, it may cause condensation and fog the glass. This condensation is normal and will disappear in a few minutes as the glass heats up.

DO NOT BURN THE APPLIANCE WITHOUT THE GLASS FRONT IN PLACE.

DO NOT BURN THE APPLIANCE WITHOUT THE GLASS FRONT IN PLACE.

AUTOMATIC

CONVECTION

FAN OPERATION

Set the fan speed on control panel at the top rear of the unit to adjust to the desired speed. The fan will turn on as the stove comes up to operating temperature.Afterthe unit has been turned off and the unit cooled

to below a useful heat output range the fan will shut off automati- cally.

ADJUSTING FLAME

HEIGHT

Your heater has an adjustable fl ame to tailor the look and heat output to your specifi c needs. It is adjusted by turning the fl ame adjustment dial on the gas control valve.

Turn clockwise to adjust the fl ame higher, coun- terclockwise for a lower fl ame.

WARNING

DO NOT SPRAY AEROSOLS IN

THE VICINITY OF THIS

APPLIANCE WHILE IN

OPERATION

14

Regency F38-2 Freestanding Gas Stove

Image 14
Contents Manual Please Keep These Instructions For Future ReferenceTo the New Owner Table of Contents Safety Label General Information InstallationGeneral Safety Information Before YOU StartDraft Diverter Installation ChecklistClearances to Combustibles FlueingFlueing Requirements GAS Pipe Pressure TestingGAS Connection T. Valve Description#52 and tighten Conversion KIT# 731-968 from NG to LPGLPG Conversion Kit Contains Qty Reverse steps 3 toF38-2 with 38 mj Aeration AdjustmentLOG SET Installation E02-45 F02-47 A02-65 D02-46 B02-56 C02-44 Front Door Installation Test for Flue SpillageFinal Check 14 GA 15.24 16 GA 18 GA 20 GA 22 GAWiring Operating Instructions For Your Safety Read Before Lighting Copy of the Lighting Plate InstructionsPilot Adjustment Normal Operating Sounds GAS AppliancesMaintenance Install door catch plate FAN MaintenanceInstalling Glass Withoutthefanaccesspanelsecurely Place and correctly sealedRemoving Valve Part# Aust. New Zealand Description Parts ListF38-2 Main Assembly F38-2 Burner & LOG Assembly F38-2 Door Assemblies DescriptionWarranty Western Australia Eastern Australia

F38-NG2, F38-LPG2 specifications

Regency Wraps is known for its innovative approach to creating stylish and functional clothing storage solutions. Among their notable offerings are the F38-NG2 and F38-LPG2 garment bags. These bags blend practicality and aesthetics, catering to the needs of individuals looking to store and transport their garments with care and style.

The F38-NG2 is designed with a focus on durability and protection. Made from high-quality nylon fabric, it provides excellent resistance to wear and tear while also being lightweight for easy handling. One of the key features of this garment bag is its spacious interior, allowing users to store multiple garments without worrying about creasing or damage. The innovative design includes breathable ventilation that helps prevent odors and keeps clothes fresh during travel or storage. Additionally, the translucent window enables quick visibility of the contents, eliminating the hassle of searching through a packed bag.

On the other hand, the F38-LPG2 caters to a slightly different demographic with its luxurious polyester fabric. This elegant material not only enhances the bag’s aesthetic appeal but also adds a layer of protection against dust, dirt, and moisture. The F38-LPG2 is particularly well-suited for formal attire, such as evening gowns and suits. Its padded interior offers extra cushioning for delicate fabrics, ensuring that garments remain in pristine condition. Like its counterpart, this bag features a convenient clear window, allowing users to identify garments at a glance.

Both the F38-NG2 and F38-LPG2 incorporate advanced technologies, such as anti-static linings. These linings help reduce static cling, providing an extra level of care for garments made from synthetic materials. Additionally, both bags come with sturdy zippers and reinforced handles for enhanced durability, ensuring that they can withstand the rigors of frequent use.

In conclusion, the Regency Wraps F38-NG2 and F38-LPG2 garment bags are ideal choices for individuals seeking quality and functionality in their clothing storage solutions. With their thoughtful designs, high-quality materials, and protective features, these bags are perfect for traveling, seasonal storage, or simply keeping your wardrobe organized. Whether you prefer the rugged advantage of the F38-NG2 or the sophisticated elegance of the F38-LPG2, both options reflect Regency Wraps' commitment to quality and innovation in garment care.