Regency Wraps F38-NG2, F38-LPG2 installation manual Maintenance

Page 17

MAINTENANCE

MAINTENANCE

INSTRUCTIONS

1)Always shut the valve off before cleaning. For relighting, refer to lighting instructions. Keep the burner and control compartment clean by brushing and vacuuming at least once a year. When cleaning the logs, use a soft clean brush as the logs are fragile and easily damaged.

2)Clean glass (never when unit is hot), appli- ance, louvres, and door with a damp cloth. Never use an abrasive cleaner. The gold louvres (and optional gold door) may be scratched if abrasives are used to clean them.

The heater is fi nished in a heat resistant paint and should only be refi nished with heat resistant paint (not with wall paint). Regency uses StoveBright Paint - Metallic Black #6309.

3)Make a periodic check of burner for proper position and condition. Visually check the flame of the burnerperiodically,makingsure the fl ames are steady; not lifting or fl oating. If there is a problem, call an authorized service person.

4)The appliance and fl ueing system must be inspected before use, and at least annu- ally, by an authorized fi eld service person, to ensure that the fl ow of combustion and ventilation air is not obstructed.

During the annual service call, the burners should be removed from the burner tray and cleaned. Replace the embers - do not block the pilot or burner ports.

5)Keep the area near the appliance clear and free from combustible materials, gasoline and other fl ammable

vapours and liquids.

WARNING:CHILDRENANDADULTS SHOULD BE ALERTED TO THE HAZARDS OF HIGH SURFACE TEMPERATURE AND SHOULD STAY AWAY TO AVOID BURNS OR CLOTHING IGNITION. YOUNG CHILDREN SHOULD BE CARE- FULLY SUPERVISED WHEN THEY ARE IN THE SAME ROOM AS THE APPLIANCE.

CAUTION: ANY SAFETY SCREEN OR GUARD REMOVED FOR SERV- ICING AN APPLIANCE MUST BE REPLACED PRIOR TO OPERATING THE APPLIANCE.

CLOTHING OR OTHER FLAMMA- BLE MATERIAL SHOULD NOT BE PLACED ON OR NEAR THE AP- PLIANCE.

DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. IMMEDIATELY CALL AN AUTHORIZED SERVICE TECHNI- CIAN TO INSPECT THEAPPLIANCE AND TO REPLACE ANY PART OF CONTROL SYSTEM AND ANY GAS CONTROL WHICH HAS BEEN UN- DER WATER.

6)Verify proper operation after servicing.

LOG REPLACEMENT

The unit should never be used with broken logs. Turn off the gas valve and allow the unit to cool before opening door to carefully remove the logs. The pilot light generates enough heat to burn someone. If for any reason a log should need replacement, you must use the proper replacement log. The position of these logs must be as shown in the diagram under Log Installation.

Note: Improper positioning of logs may cre- ate carbon build-up and will alter the unit’s performance which is not covered under warranty.

DOOR AND

GLASS GASKET

If the door gasket requires replacement use 7/8" diameter oval door gasket (Part # 650-920). The glass requires 5/8" fl at glass gasket. See your Regency dealer.

GOLD-PLATED DOORS

The 24 carat gold plated fi nish on the door requires little maintenance, and need only be cleaned with a damp cloth. DO NOT use abrasive materials or chemical cleaners, as they may harm the fi nish and will void the warranty. Clean any fi ngerprints off before turning the unit on.

GLASS

REPLACEMENT

Your Regency heater is supplied with high temperature, 5mm Neoceram silica coated ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break your glass, purchase your re- placement from an authorized Regency dealer only, and follow the step-by-step instructions for replacement.

Removing Glass:

Note: Wearing gloves will protect your

hands while handling glass.

1)Remove the door from the unit and place on a soft surface to prevent scratching.

2)Pull out the door gasket.

3)Remove the 24 nuts holding the glass retainers in place. Do not remove the nuts underneath the retainers.

4)Remove the door catch plate.

5)Removeglassretainersonsidesfirst(3each side) then remove two center retainers.

Note: Center glass retainers are glued to center glass.

6)Remove glass from aluminium extrusions. When removing center glass, leave white insulation in place.

Safety Screen: Only required in Australia

Regency F38-2 Freestanding Gas Heater

17

Image 17
Contents Please Keep These Instructions For Future Reference ManualTo the New Owner Table of Contents Safety Label General Safety Information InstallationGeneral Information Before YOU StartClearances to Combustibles Installation ChecklistDraft Diverter FlueingGAS Connection GAS Pipe Pressure TestingFlueing Requirements T. Valve DescriptionLPG Conversion Kit Contains Qty Conversion KIT# 731-968 from NG to LPG#52 and tighten Reverse steps 3 toF38-2 with 38 mj Aeration AdjustmentLOG SET Installation E02-45 F02-47 A02-65 D02-46 B02-56 C02-44 Test for Flue Spillage Front Door Installation14 GA 15.24 16 GA 18 GA 20 GA 22 GA Final CheckWiring Operating Instructions Copy of the Lighting Plate Instructions For Your Safety Read Before LightingNormal Operating Sounds GAS Appliances Pilot AdjustmentMaintenance Installing Glass FAN MaintenanceInstall door catch plate Withoutthefanaccesspanelsecurely Place and correctly sealedRemoving Valve Part# Aust. New Zealand Description Parts ListF38-2 Main Assembly F38-2 Burner & LOG Assembly Description F38-2 Door AssembliesWestern Australia Eastern Australia Warranty

F38-NG2, F38-LPG2 specifications

Regency Wraps is known for its innovative approach to creating stylish and functional clothing storage solutions. Among their notable offerings are the F38-NG2 and F38-LPG2 garment bags. These bags blend practicality and aesthetics, catering to the needs of individuals looking to store and transport their garments with care and style.

The F38-NG2 is designed with a focus on durability and protection. Made from high-quality nylon fabric, it provides excellent resistance to wear and tear while also being lightweight for easy handling. One of the key features of this garment bag is its spacious interior, allowing users to store multiple garments without worrying about creasing or damage. The innovative design includes breathable ventilation that helps prevent odors and keeps clothes fresh during travel or storage. Additionally, the translucent window enables quick visibility of the contents, eliminating the hassle of searching through a packed bag.

On the other hand, the F38-LPG2 caters to a slightly different demographic with its luxurious polyester fabric. This elegant material not only enhances the bag’s aesthetic appeal but also adds a layer of protection against dust, dirt, and moisture. The F38-LPG2 is particularly well-suited for formal attire, such as evening gowns and suits. Its padded interior offers extra cushioning for delicate fabrics, ensuring that garments remain in pristine condition. Like its counterpart, this bag features a convenient clear window, allowing users to identify garments at a glance.

Both the F38-NG2 and F38-LPG2 incorporate advanced technologies, such as anti-static linings. These linings help reduce static cling, providing an extra level of care for garments made from synthetic materials. Additionally, both bags come with sturdy zippers and reinforced handles for enhanced durability, ensuring that they can withstand the rigors of frequent use.

In conclusion, the Regency Wraps F38-NG2 and F38-LPG2 garment bags are ideal choices for individuals seeking quality and functionality in their clothing storage solutions. With their thoughtful designs, high-quality materials, and protective features, these bags are perfect for traveling, seasonal storage, or simply keeping your wardrobe organized. Whether you prefer the rugged advantage of the F38-NG2 or the sophisticated elegance of the F38-LPG2, both options reflect Regency Wraps' commitment to quality and innovation in garment care.