Regency Wraps F38-NG2, F38-LPG2 installation manual Copy of the Lighting Plate Instructions

Page 15

OPERATING INSTRUCTIONS

COPY OF THE LIGHTING PLATE INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING

This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or Natural Gas and Propane Installation Codes, CSA B149.1. (Australia: AS5601-2004, New Zealand: NZS 5261)

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appliance. For assistance or additional information consult a qualified installer, service agency or gas supplier.

A) This appliance has a pilot which must be lighted

a qualified service technician. Force or attempted

by hand, following the instructions below

repair may result in a fire or explosion.

exactly.

D) Do not use this appliance if any part has been under

B) BEFORE LIGHTING smell all around the appliance

water. Immediately call a qualified service techni-

area for gas. Be sure to smell next to the floor

cian to inspect the appliance and to replace any part

because some gas is heavier than air and will

of the control system and any gas control which has

settle on the floor.

been under water.

WHAT TO DO IF YOU SMELL GAS

This appliance needs fresh air for safe operation and

- Do not try to light any appliance

must be installed so there are provisions for adequate

- Do not touch any electric switch, do not use any

combustion and ventilation air.

phone in your building

CAUTION: Hot while in operation. Do not touch.

- Immediately call your gas supplier from a

neighbors phone. Follow the gas supplier’s in-

Severe Burns may result. Due to high surface

structions.

temperatures keep children, clothing and

- If you cannot reach your gas supplier, call the

furniture, gasoline and other liquids having

fire department.

fammablevaporsaway.Keepburnerandcontrol

C)Use only your hand to push in or turn the gas compartment clean. See installation and

control knob. Never use tools. If the knob will not operatinginstructionsaccompanyingappliance.

push in or turn by hand, don’t try to repair it, call

LIGHTING INSTRUCTIONS

STOP! Read the safety information above on this

Release knob and it will pop back up. Pilot should

label.

 

 

 

remain lit. If it goes out, repeat steps 3) and 4).

1) Push in gas control knob slightly and turn

If knob does not pop up when released, stop and

clockwise

to “OFF”. Knob cannot be turned

immediately call your service technician or gas

from “PILOT” to “OFF” unless knob is pushed in

supplier.

 

 

slightly. Do

not

force.

 

If the pilot will not stay lit after several tries, turn the

2) Wait five (5) minutes to clear out any gas. If you

gas control knob to “OFF” and call your service

then smell gas STOP! follow “B” in the safety

technician or gas supplier.

 

 

information above on this label. If you don’t smell

5) Turn gas control knob counterclockwise

to “ON”.

gas, go to the next step.

 

6) Use rocker switch to operate main burner.

3) Turn knob

on

gas control

counterclockwise

PILOT BURNER

 

 

to “PILOT”.

 

 

VEILLEUSE

 

OFF

4) Push in control

knob all the

way and hold in.

THERMOPILE

 

 

Immediately push black button on spark igniter

 

 

ELEMENT

Gas Inlet

 

until pilot

lights. Continue to

hold the control

 

THERMO-

 

 

knob in for about 1/2 minute after the pilot is lit.

 

 

ELECTRIQUE

 

 

TO TURN OFF GAS APPLIANCE

1) Push in the gas control knob slightly and turn

clockwise

to “OFF”. Do not force.

2)Turn off all electric power to the appliance if service is to be performed.

You may shut off the pilot during prolonged non use periods to conserve fuel.

DO NOT REMOVE THIS INSTRUCTION PLATE

908-649c

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WARNING:

DO NOT SPRAY AEROSOLS IN THE VICINITY OF

THIS APPLIANCE WHILE IN OPERATION.

Regency F38-2 Freestanding Gas Heater

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Please Keep These Instructions For Future Reference ManualTo the New Owner Table of Contents Safety Label Before YOU Start InstallationGeneral Safety Information General InformationFlueing Installation ChecklistClearances to Combustibles Draft DiverterT. Valve Description GAS Pipe Pressure TestingGAS Connection Flueing RequirementsReverse steps 3 to Conversion KIT# 731-968 from NG to LPGLPG Conversion Kit Contains Qty #52 and tightenAeration Adjustment LOG SET InstallationF38-2 with 38 mj E02-45 F02-47 A02-65 D02-46 B02-56 C02-44 Test for Flue Spillage Front Door Installation14 GA 15.24 16 GA 18 GA 20 GA 22 GA Final CheckWiring Operating Instructions Copy of the Lighting Plate Instructions For Your Safety Read Before LightingNormal Operating Sounds GAS Appliances Pilot AdjustmentMaintenance Withoutthefanaccesspanelsecurely Place and correctly sealed FAN MaintenanceInstalling Glass Install door catch plateRemoving Valve Parts List F38-2 Main AssemblyPart# Aust. New Zealand Description F38-2 Burner & LOG Assembly Description F38-2 Door AssembliesWestern Australia Eastern Australia Warranty

F38-NG2, F38-LPG2 specifications

Regency Wraps is known for its innovative approach to creating stylish and functional clothing storage solutions. Among their notable offerings are the F38-NG2 and F38-LPG2 garment bags. These bags blend practicality and aesthetics, catering to the needs of individuals looking to store and transport their garments with care and style.

The F38-NG2 is designed with a focus on durability and protection. Made from high-quality nylon fabric, it provides excellent resistance to wear and tear while also being lightweight for easy handling. One of the key features of this garment bag is its spacious interior, allowing users to store multiple garments without worrying about creasing or damage. The innovative design includes breathable ventilation that helps prevent odors and keeps clothes fresh during travel or storage. Additionally, the translucent window enables quick visibility of the contents, eliminating the hassle of searching through a packed bag.

On the other hand, the F38-LPG2 caters to a slightly different demographic with its luxurious polyester fabric. This elegant material not only enhances the bag’s aesthetic appeal but also adds a layer of protection against dust, dirt, and moisture. The F38-LPG2 is particularly well-suited for formal attire, such as evening gowns and suits. Its padded interior offers extra cushioning for delicate fabrics, ensuring that garments remain in pristine condition. Like its counterpart, this bag features a convenient clear window, allowing users to identify garments at a glance.

Both the F38-NG2 and F38-LPG2 incorporate advanced technologies, such as anti-static linings. These linings help reduce static cling, providing an extra level of care for garments made from synthetic materials. Additionally, both bags come with sturdy zippers and reinforced handles for enhanced durability, ensuring that they can withstand the rigors of frequent use.

In conclusion, the Regency Wraps F38-NG2 and F38-LPG2 garment bags are ideal choices for individuals seeking quality and functionality in their clothing storage solutions. With their thoughtful designs, high-quality materials, and protective features, these bags are perfect for traveling, seasonal storage, or simply keeping your wardrobe organized. Whether you prefer the rugged advantage of the F38-NG2 or the sophisticated elegance of the F38-LPG2, both options reflect Regency Wraps' commitment to quality and innovation in garment care.
Top Page Image Contents