Regency P121RC-NG, P131-NG Copy of the Lighting Plate Instructions, Maintenance Instructions

OPERATING INSTRUCTIONS

COPY OF THE LIGHTING PLATE INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING

This appliance must be installed in accordance with local codes, if any; if not, follow the current CAN1-B149/ANSI Z 223.1 (Australia: AS5601-2004, New Zealand: NZS 5261)

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss oflife.Improperinstallation,adjustment,alteration,serviceormaintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appliance. For assistance or additional information consult a qualified installer, service agency or gas supplier.

A)This appliance has a pilot which	C)Use only your hand to push in or turn
must be lighted by hand. When	the gas control knob. Never use tools.
lighting the pilot, follow these	If the knob will not push in or turn by
instructions exactly.	hand, don’t try to repair it, call a
	qualified service technician. Force or
B)BEFORE LIGHTING smell all around	attempted repair may result in a fire
the appliance area for gas. Be sure	or explosion.
to smell next to the floor because
some gas is heavier than air and	D)Do not use this appliance if any part
will settle on the floor.	has been under water. Immediately
	call a qualified service technician to
WHAT TO DO IF YOU SMELL GAS	inspect the appliance and to replace
- Do not try to light any appliance	any part of the control system and any
- Do not touch any electric switch, do	gas control which has been under
not use any phone in your building	water.
- Immediately call your gas supplier
from a neighbours phone. Follow	This appliance needs fresh air for safe
the gas supplier’s instructions.	operation and must be installed so there

-If you cannot reach your gas are provisions for adequate combustion supplier, call the fire department. and ventilation air.

CAUTION:Hotwhileinoperation.Donottouch.SevereBurnsmayresult.Due to high surface temperatures keep children, clothing and furniture, gasoline and other liquids having fammable vapors away. Keep burner and control compartment clean. See installation and operating instructions

accompanying appliance.

LIGHTING INSTRUCTIONS

STOP! Read the safety information above on this label.

1)Push in gas control knob slightly and turn to “PILOT” position.

2)Push in control knob all the way and hold in until the pilot lights up. Continue to hold the control knob in for about 20 seconds after the pilot is lit. Release knob.

3)Push in gas control knob slightly and

turn to "ON" position. Gas Inlet

4) Turn ON the flame switch.

TO TURN OFF GAS APPLIANCE

You may shut off the pilot during prolonged non use periods to conserve fuel.

1)Turn OFF the flame switch.

2)Push in gas control knob slightly and turn to "OFF" position.

DO NOT REMOVE THIS INSTRUCTION PLATE

918-253a

MAINTENANCE

INSTRUCTIONS

1)Always turn off the gas valve before cleaning. For relighting, refer to lighting instructions. Keep the burner and control compartment clean by brushing and vacu- uming at least once a year. When cleaning the logs, use a soft clean paint brush as the logs are fragile and easily damaged.

2)Clean appliance and door with a damp cloth (never when unit is hot). Never use an abrasive cleaner. The glass should be cleaned with a gas fireplace glass cleaner.

The glass should be cleaned when it starts looking cloudy.

3)The heater is finished in a heat resistant paint and should only be refinished with heat resistant paint. Regency uses Stove- Bright Paint - Metallic Black #6309.

4)Make a periodic check of burner for proper position and condition. Visually check the flame of the burner periodically, making sure the flames are steady; not lifting or floating. If there is a problem, call a author- ized service person.

5)The appliance and flueing system must be inspected before use, and at least annual- ly, by a authorized field service person, to ensure that the flow of combustion and ventilation air is not obstructed.

Note: Never operate the appliance with- out the glass properly secured in place.

6)Do not use this appliance if any part has been under water. Immediately call a au- thorized service technician to inspect the appliance and to replace nay part of the control system and any gas control which has been under water.

7)In the event this appliance has been serv- iced check that the flue-air system has been properly resealed & reinstalled in accordance with the manufacturer's in- structions.

8)Verify operation after servicing.

General Flue Maintenance

Conduct an inspection of the flueing system semi-annually. Recommended areas to inspect as follows:

1)Check the Flueing System for corrosion in areas that are exposed to the elements. These will appear as rust spots or streaks, and in extreme cases, holes. These com- ponents should be replaced immediately.

30 Regency P121/P121LC/P121RC/P131 Zero Clearance Room Sealed Gas Fireplace