Danby DPAC5009 manual Troubleshooting, Problem Possible Cause Solutions

TROUBLESHOOTING

Occasionally, a problem may occur that is minor, and a service call may not be necessary. Use this troubleshooting guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot for assistance, or Danby’s Toll Free Number: 1-800-26-

PROBLEM	POSSIBLE CAUSE	SOLUTIONS
	• Power is out.	• Wait for power to return.
	• The plug is not plugged in properly.
1) Unit does not work		• Plug in properly.
	• The full-tank indicator is ON; tank is	• Remove drain water from the drain
	full.	tank.
	• Current leaking or pressing test
		• Press the reset button after resolving
	button on LCDI plug.
		problem.
	• Indoor set temperature has been	• Reset the temperature level.
2) Unit suddenly stops during operation.	reached.
		• Reset the timer.
	• The preset time is up.	• Remove drain water from the drain
	• The full-tank indicator is ON; tank is
	full.	tank.
3) Unit runs intermittently	• Malfunction.	• Contact your dealer.
	• Surrounding temp. is too high/low.	• This is normal.
	• Exhaust duct hose is blocked.	• Check the duct hose.
	• Window or door is open in room.	• Close all windows/doors.
4) Unit functions but the room is not	• There is a heat source or too many
	people in the room.	• Move any heat sources from room.
cooled.	• Air intake grill is clogged.	• Clean air intake grill.
	• Filter is too dirty.	• Replace the filter.
	• Temperature setting is too high.	• Lower temp. setting.
5) Condensed water spills out when	• The tank is nearly full.	• Remove drain plug on rear bottom
moving the unit.		and drain out water.

9