OPERATION (cont’d)
AUTO-TIMER
The
a)
b)
Note: These functions must be performed daily, as the program is automatically canceled/erased after the program has ended.
TIMER SETTING
CONTROL
Press the Timer button on the remote control to set the timer. The “ON” or “OFF” logos (depending on timer mode “A” or “B” below) will appear in the display panel, the clock symbol will flash for approximately 10 seconds, and the display panel will show the time of 8 hrs. While the clock symbol is flashing, press the 
UP and 
DOWN buttons on the remote control to select the time (in hours, between 00 and 24) for either
of the timer modes “A” or “B” as detailed below. The time selected will be shown on the display panel and after approximately 10 seconds the clock symbol will remain illuminated together with either the “ON” or “OFF” logo.
Timer mode A) Auto Off: With the machine on and running, set the timer to select the number of hours you would like the unit to run until it automatically shuts off. The set time will be shown in the display together with the clock symbol and “OFF” logo.
Timer mode B) Auto On: Switch the machine on using the ON/OFF button (either on the machine itself or on the remote control) so that the machine is running and the desired mode is selected. Press the ON/OFF button again to put the machine in
TIMER CANCEL
CONTROL
If the time has been set as in either “A” or “B” above, and it is then decided that the timer is not required, pressing the CANCEL button will turn the timer off.
7