Integra DTR-5.9 instruction manual Miscellaneous Setup, Volume Setup, OSD Setup

Advanced Setup—Continued

Miscellaneous Setup

This section explains items on the Miscellaneous menu.

1	Press the [Receiver] Remote
	Mode button, followed by the
	[Setup] button.

The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

2	Use the Up and Down [	]/[	]
	buttons to select
	“6. Miscellaneous,” and then
	press [Enter].
3	Use the Up and Down [	]/[	]

buttons to select an item, and then press [Enter].

4	Use the Up and Down [	]/[	]
	buttons to select an item, and
	use the Left and Right [	]/[	]
	buttons to change it.

The items are explained below.

5	When you’ve finished, press the
	[Setup] button.
	Setup closes.

Note:

•This procedure can also be performed on the AV receiver by using its [Setup], [Enter], and arrow but- tons.

Volume Setup

■Maximum Volume

With this setting, you can limit the maximum volume. The Maximum Volume range is Off, 79 to 30.

■Power On Volume

This setting determines what the volume will be each time the AV receiver is turned on.

The range is Last, Min, 1 to 79, Max.

To use the same volume level as when the AV receiver was last turned off, select Last.

Note:

•The Power On Volume setting cannot be set higher than the Maximum Volume setting.

■Headphone Level

With this setting, you can offset the headphone volume relative to the main volume. This is useful if your head- phones are too loud or too quiet at the volume setting you usually use when listening through your speakers. The headphone level can be set from –12 dB to +12 dB.

■Zone 2 Maximum Volume

With this setting, you can limit the maximum volume for Zone 2.

The Maximum Volume range is Off, 79 to 30.

■Zone 2 Power On Volume

This setting determines what the volume will be for Zone 2 each time the AV receiver is turned on.

The range is Last, Min, 1 to 79, Max.

To use the same volume level as when the AV receiver was last turned off, select Last.

OSD Setup

■Immediate Display

This setting determines whether operation details are displayed onscreen immediately after an AV receiver function is used.

On: Displayed (default).

Off: Not displayed.

Even if On is selected, operation details are not output if the input source is connected to a COMPONENT VIDEO IN or HDMI IN.

■Monitor Type

With this setting, you can specify the aspect ratio of your TV so that menus are displayed properly.

16:9: Select if your TV is 16:9 (default). 4:3: Select if your TV is 4:3.

■Display Position

This setting determines where on the screen operation details are displayed.

Bottom: Bottom of the screen (default).

Top: Top of the screen.

■TV format (not North American model)

For the onscreen setup menus to display properly, you must specify the TV system used in your area.

Auto: Select this to have the AV receiver automati- cally detect the TV system from the video input signals.

NTSC: Select if the TV system in your area is NTSC. PAL: Select if the TV system in your area is PAL.

88