Integra DTR-5.9 instruction manual Hardware Setup, Remote Control

Advanced Setup—Continued

Hardware Setup

This section explains items on the Hardware menu.

Remote indicator

Receiver

Eenter

Setup

Number buttons

1	Press the [Receiver] Remote
	Mode button, followed by the
	[Setup] button.

The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

2	Use the Up and Down [ ]/[ ]
	buttons to select “7. Hardware
	Setup,” and then press [Enter].

3	Use the Up and Down [ ]/[ ]
	buttons to select an item, and
	then press [Enter].
	The screen for that item appears.

4	Use the Up and Down [	]/[	]
	buttons to select an item, and
	use the Left and Right [	]/[	]

buttons to change it.

The items are explained below.

5	When you’ve finished, press the
	[Setup] button.
	Setup closes.

Note:

•This procedure can also be performed on the AV receiver by using its [Setup], [Enter], and arrow but- tons.

Remote Control

■Remote ID

When several Integra/Onkyo components are used in the same room, their remote ID codes may overlap. To dif- ferentiate the AV receiver from the other components, you can change its remote ID from 1, the default, to 2 or 3.

Note:

•If you do change the AV receiver’s remote ID, be sure to change the remote controller to the same ID (see below), otherwise, you won’t be able to control it with the remote controller.

Changing the Remote Controller’s ID

1	While holding down the
	[Receiver] Remote Mode button,
	press and hold down the [Setup]
	button until the Remote indicator
	lights up (about 3 seconds).

(3 seconds)

89