Integra DTR-9.1 appendix Using a Macro function, Programming the Direct Macro function

Using a Macro function

POWER ON

DIRECT MACRO CD MODE

MODE buttons

AUDIO/TAPE MODE

AUDIO MUTING

TRACKDISC

(CD playback)

REC			OPEN/COLSE
DVD			CD	CD
				(INPUT
T1	T2	TUN	PH	SELECTOR)
V1	V2	V3	V–
STEREO		DIRECT	DSP
1		2	3
SURROUND		THX	DSP
4		5	6
Re-EQ		CH SEL	LEVEL +
7		8	9
LATE NIGHT DIMMER			LEVEL –
+ 10		0	ENT

HOME THEATER CONTROLLER

RC-418M

Tips:

•If you erase or change the command of a button programmed in the direct macro, that operation of that button will no longer work in the macro. In this case, it will be necessary for you to reprogram the direct macro in order to avoid incorrect operation.

•The codes programmed into a direct macro will be transmitted at an interval of 0.5 seconds. However, some devices may not be able to complete one operation in 0.5 seconds and may miss the next code. In this case, after pressing one operation but- ton, you can press the same MODE button again before pressing the next operation button to add another 0.5 seconds between the two operations.

Programming the Direct Macro function

With the direct macro function, you can program a series of button operations as a macro into the DIRECT MACRO button so the macro can be executed with just one touch. Note that for the direct macro function, only one macro can be programmed. For example, to program the macro described on the previous page for the DIRECT MACRO button, perform the steps given below.

1.Press and hold down any one of the eight MODE buttons, press the DIRECT MACRO button, and then release both buttons.

When you press the MODE button, the SEND/LEARN indicator lights and that mode appears in the dis- play. When you press the DIRECT MACRO button, the indicator turns off. When you release the but- tons, the indicator flashes briefly and then lights again and “M 01” appears in the display.

2.Press the operation buttons you wish to

program in order (in this case,

press AUDIO/TAPE MODE → POWER ON → CD (INPUT SELECTOR) → CD MODE → playback button).

When you press each button, the SEND/LEARN indi-

cator turns off and the display changes from “M 01” → “M 02” → “M 03” → etc. When you release the button, the indicator lights.

3.Press the DIRECT MACRO button to complete the procedure.

The SEND/LEARN indicator flashes twice slowly and “SAVED” appears in the display.

4.Check to see if the macro has been properly programmed.

Notes:

•You may program up to 16 button operations into each macro function. If you try to program a 17th operation, it will be ignored, “SAVED” appears in the display, and programming is stopped.

•If no button is pressed for more than 30 seconds dur- ing the programming, the SEND/LEARN indicator flashes three times quickly, “ERROR” appears in the display, and the remote controller exits the pro- gramming mode. Resume from Step 1.

•If you perform an invalid operation during program- ming, the SEND/LEARN indicator flashes three times quickly, “ERROR” appears in the display, and the re- mote controller exits the programming mode. Re- sume from Step 1.

Running a Direct Macro function

Perform the procedure below to run a direct macro function that you have programmed into the remote controller. After programming a direct macro, you should always run it at least once to make sure that it has been programmed properly.

1. Point the remote controller at the DTR-9.1 and press the DIRECT MACRO button.

It may take a while for the macro to finish transmit- ting, so be sure to continue pointing the remote controller at the device until the SEND/LEARN indi- cator turns off.

65