Integra ST2 UNO-LRC1 Remote Control with CAV6.6, UNO-LRC1 Remote Control Operation

Page 19

ST2 OPERATION

UNO-LRC1 REMOTE CONTROL WITH CAV6.6

UNO-LRC1 Remote Control Operation

Turning the unit on

The tuner is power managed by the CAV6.6 or other RNET-enabled controller. If the tuner is in standby mode, any button press of the UNO-LRC1 will bring the tuner out of standby mode when used with the UNO keypad.

Selecting the desired tuner

To select a tuner, push and choose the source number preassigned to Tuner 1 or Tuner 2, or use the

UNO numeric source inputs at the bottom of the

UNO-LRC1.

Selecting the desired band

Push to toggle between AM/FM reception.

Selecting the desired frequency

Use the Channel and or and

for manual tuning. To move quickly through the

stations, press and hold the button for more than 1.5

seconds. To directly select a station, enter the three-

or four-digit frequency (1071 for 107.1, etc.).

European regions use five-digit station frequencies.

is reached, the tuner continues SEEK mode at the lowest frequency.

Frequency Scan

To scan, press and hold then release . The tuner scans through tuned stations with a 5-second preview before moving to the next station. To end

scanning, press again.

Selecting a Bank

To select a bank, press and hold for bank up

or for bank down.

Recalling a Memory Preset

Press and or and to scroll through a loop of all the memory presets for the cur- rently selected bank. Only configured presets will be displayed.

Mute

Press the button to mute/unmute the tuner audio output.

Frequency Seek

The SEEK function is performed by pressing and

releasing the Select or or . To seek

higher frequency station press . Press for lower frequencies. Tuning begins at the current fre-

quency, seeks upward (or downward) and stops at the

next tuned station. Pushing or again con- tinues the SEEK function. Once the highest frequency

19

Image 19
Contents ST2 Smart Tuner Safety Instructions Important SafeguardsTable of Contents Introduction RNET-enabled SystemBOX Contents ST2 Front Panel Component GuideST2 S mart Tuner ST2 Rear PanelST2-RC Remote Control Basic Connections ST2 Setup and ConnectionsST2-KP Connections to ST2 Tuner Non-RNET Systems ST2-KP and CAV6.6 ConnectionsSource Connections with CAV6.6 Controller/Amplifier Source Connections with A-BUS Audio Distribution Hub Source Connections with CAi Series Controller/AmplifierFM Antenna Connecting an Indoor and Outdoor AntennaAntenna Connections AM AntennaGrounding an Outdoor Antenna Front Panel Controls ST2 OperationFront Panel Operation Frequency Seek ST2-RC Remote Control OperationSaving Favorites ST2-KP Keypad Operation ST2-KP Keypad ControlsMute UNO-S2 Keypad Controls with CAV6.6CAV6.6-UNO-S2 Keypad Operation Frequency ScanMHz FM UNO-LRC1 Remote Control Operation UNO-LRC1 Remote Control with CAV6.6Seek UP/DOWN Seeks next tuned station up or down ST2 Chassis Setup Menu ST2 Tuner Setup MenuST2 Tuner Programming Factory Initialization Chassis Update Firmware Chassis cont’dBank Name AM/FM Tuner Setup Menu for AM/FMSystem Info Chassis Memory Name AM/FMBank Name AM/FM cont’d Backup and RestoreRegion AM/FM Programming for CAV6.6 USE Source Configuration NoteST2 Smart Tuner Technical SpecificationWarranty & Repair Russound Rev 5/24/04 28-1150