CAUTION: To prevent valve seat damage, never adjust the humidifier's water level without supporting the float arm. Make adjustments in small increments.
•To raise the water level, push down in the center of the float arm (see Figure 9, below).
•To lower the water level, hold the float on the bottom of the reser- voir with one hand and pull up on the center of the float arm with the other hand (see Figure 10, below).
CONTRACTOR
Figure 9: Raising the Water Level
Figure 10: Lowering the Water Level
5.If the water level is too high, remove enough water from the reservoir to allow the float valve to automatically fill and shut off the water. This will verify that your final adjustment is correct.
6.Mount the humidifier according to one of the options shown on pages
7.Route the tubing to the humidifier float valve, keeping the tubing away from sharp edges.
8.Connect the remaining end of the tubing to the humidifier float valve.
9.Open the saddle valve so that the water flows slowly and gently into the water pan.
23