Typical Installation
Union
Heat Trap
6" (15cm)
Min.
Hot Water
Outlet t o
Fixtures
Flue Pipe (ABS or PVS)
to Outside Vent Terminal
Blower Assembly
Pitch up 1/4" per foot
Rubber Coupling
Anode
(locate d undernea th
Temperatu re & Pressure Relief Valve
Union
Blower Assembly)
Manual Gas
To Gas
Supply
Ground Join t Union
Sediment Trap
Cap
Heat Trap
6" (15cm) Min.
To Cold
Water Supply
Thermal Expansion
Tank
(If Required)
Drain Valve
NOTICE: The National Fuel Gas Code (NFGC) or CAN/CSA B149, Installation Code, mandates a manual gas
Thermostatic
Gas Valve
Jacket Door
Auxiliary Catch Pan
Drain Pan Pipe to suitable drain
Relief valve discharge line to suitable open
drain
Air Gap 6" (15cm)
Local codes or plumbing authority requirements may vary from the instructions or diagrams provided and take precedent over these instructions.
Vacuum Relief Valve
(Not Supplied)
If required, install per local codes
and valve manufacturer’s
instructions.
17