USER MANUAL
ENGLISH
MACHINE START AND STOP
WARNING!
Do not operate machine unless you have read and understand this manual.
1.Set control housing to a comfortable operating height by squeezing together the two thumb levers directly underneath the housing. (see machine components, item #10)
2.Lower squeegee assembly to the floor by releasing the lift lever from its locked position.(see machine components, item #13)
3.Lower brush head assembly to the floor by stepping on the foot pedal and pushing pedal forward. (see machine components, item #8)
4.Turn main power to “on” position.(see machine components,item#24)
5.Turn brush motor to “on” position. (see machine components, item #2)
6.Turn vacuum motor switch to “on” position.(see machine components, item #1)
7.Turn the solution switch to “on” position. (seemachine components, item #4)
a. Solution will not begin to flow until the operating triggers are pulled.
8.The Fang
9.The Fang
10.To begin scrubbing, pull on one or both of the red operating triggers. (see machine components, item #23) When these triggers are pulled, the brush will begin to spin and the solution will begin to flow.The Fang
11.The Fang
WARNING!
Do not keep the machine in the same position with the pad / brush spinning, or you could cause damage to the floor.
12.Adjust amount of solution flow by turning the solution control knob. Turn to the right for more solution, or turn left for less solution. (see machine components, item #5)
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Alto suggests to go near the walls with the right side of the machine as shown .
A
B
CAUTION!
To avoid any damage to the floor surface, turn off the
SCRUBBERS |
13