ENGLISH USER MANUAL
BASIC TROUBLESHOOTING
PROBLEM | CAUSE | SOLUTION | |
No power | Batteries gives no electricity | Replace batteries | |
| Batteries need to be charged | Charge batteries (see Battery Charging) | |
| Loose battery cable | Tighten loose cable(s) | |
| Batteries not connected properly | Follow battery installation instructions | |
Brush motor does | Bad brush switch | Contact Viper dealer | |
not run | |||
|
| ||
| Brush circuit breaker has tripped | Check brush motor for obstructions and reset breaker | |
| Rectifier has burned out | Contact Viper Dealer | |
| Bad wiring | Contact Viper Dealer | |
| Brush motor is not turing around | Contact Viper Dealer | |
| Carbon brushes worn out | Contact Viper Dealer | |
| Bad solenoid | Contact Viper Dealer | |
Vacuum motor does | Bad vacuum switch | Contact Viper Dealer | |
not run | |||
|
| ||
| Bad wiring | Contact Viper Dealer | |
| Bad vacuum motor | Contact Viper Dealer | |
| Carbon brushes worn out | Contact Viper Dealer | |
Short run time | Batteries need to be charged | Charge batteries (see Battery Charging) | |
| Batteries need maintenance | See Battery Maintenance in this manual | |
| Bad cell in battery(s) | Replace batteries | |
| Bad charger | Replace charger | |
Little or no solution | Bad solution switch | Contact Viper Dealer | |
flow | |||
|
| ||
| Clogged solution solenoid | Contact Viper Dealer | |
| Clogged solution filter | Remove filter and clean | |
| Solution line obstructed | Remove solution line and clean | |
| Solution flow adjustment knob in need | Increase flow by twisting solution adjustment knob to the | |
| right. Decrease flow by twisting solution adjustment knob | ||
| of adjustment | to the left. | |
|
| ||
Poor water pick up | Squeegee clogged | Clean debris off squeegee with damp towel | |
| Squeegee blades worn | Install new squeegee blades | |
| Squeegee not mounted correctly | Confirm that the squeegee assembly is securely fastened | |
| to the machine and not loose fitting. | ||
|
| ||
| Vacuum hoses have a hole or are loose | Check hose connections and make sure they are firm. | |
| Replace hose if damaged. | ||
|
| ||
| Vacuum hose may be clogged | Check hose for debris and remove any clog. | |
| Drain hose stopper is loose | Tighten drain plug. | |
| Batteries need to be charged | Charge batteries (see Battery Charging) | |
| Vacuum motor is loose | Tighten vac motor mounting screws. Do not overtighten or | |
| damage will occur. | ||
|
| ||
| Recovery tank lid is loose | Confirm the clear recovery tank lid is securely in place. | |
| Recovery tank inlet hole is clogged | Drain recovery tank and tilt tank on side. Check the inlet | |
| hole for debris and remove debris. | ||
|
| ||
| Recovery tank is full | Drain recovery tank. | |
| Float shut off is clogged | Remove float shut off from inside recovery tank and | |
| remove any debris. | ||
|
|
20
SCRUBBERS |