USER MANUAL
ENGLISH
WHILE OPERATING MACHINE
1.Occasionally look through the clear recovery tank lid to see if there is any foam
WARNING!
Foam must not enter the float
2.Occasionally view the clear tube at the back left of the machine to check the amount of cleaning solution that is left in the machine.
3.Occasionally check the battery level meter. (see machine components, item #3) When meter is in the red, recharge the batteries.
WARNING!
When battery meter is in the red, do not continue to operate the machine. Battery damage may result.
4. If the squeegee assembly leaves streaks on the floor, raise the squeegee off the floor and wipe the blades down with a damp cloth.
WARNING!
Do not use your fingers to wipe or remove debris from the blades, as injury may occur.
5.When the solution tank runs empty, turn off the brush switch, solution switch and raise the brush head. Keep the squeegee down and continue to vacuum until all the dirty water is picked up. (see TANK DRAINING section to learn how to drain recovery and solution tanks)
NOTE
The brush motor is circuit breaker protected to protect it from damage. If this breaker trips, it can’t be reset immediately. You must first determine what caused the breaker to trip, and allow the motor to cool down before you can reset the breaker. The breaker is located on the back panel of the control housing.
SCRUBBERS |
15