Viper FANG 20T-EU user manual English, Solution flow adjustment, Battery discharge during operation

ENGLISH USER MANUAL

Solution flow adjustment

1.Turn the solution switch (A) to “ON” position.

2.Adjust amount of solution flow by turning the solution control knob (B), turn left (counter-clockwise) for more solution, or Turn right (clockwise) for less solution. The pin (C) is limit position of the solution control knob (B).

NOTE

Even if turn on the solution switch (A) ,the solution will not begin to flow until the operating triggers (D) are pulled.

Battery discharge during operation

Until the green warning light (3)stays on, the batteries allow the machine to work normally.

When the green warning light (3) turns off, and the yellow warning light (3) turns on, it is advisable to charge the batteries, because the residual autonomy will last for a few minutes (depending on battery characteristics and work to be performed).

When the red warning light (3) turns on, the autonomy is over. After a few seconds, the brush/pad-holder is automatically tuned off, while the vacuum system and the drive system stay on, to finish drying the floor and drive the machine to the appointed recharging area.

CAUTION!

Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.

14

SRUBBERS FANG20-EU / FANG20T-EU 82089E(1)2009-04 A