Admiral AAW-18CR1FHUE, AAW-15CR1FHUE manual Preparation to Remove Air Conditioner Slide-Out Chassis

Page 11

WAC 8-24 USER MAN FINAL 3/2/05 12:13 PM Page 11

INSTALLATION INSTRUCTIONS

2. Preparation to Remove the

Air Conditioner Slide-Out Chassis

A. Remove total of (4) Philips screws securing the chassis to the cabinet. There are (2) screws on each side. The set of screws closest to the front of the unit secure the front panel to the cabinet. The set of screw closest to the rear of the unit secure the cabinet to the chassis.

See (Fig. 1).

Right side

Philips screws

Fig. 1

B. Remove the front panel assembly from the cabinet by gently pulling it.

C. Grasp the pull handle at the front of the slide-out chassis and carefully slide the

air conditioner out of the cabinet. See (Fig. 2).

Please seek assistance for this procedure.

Note: Screws must be reinstalled upon completion of the window installation to secure slide-out chassis.

3.Assembly of the upper & lower channels to the cabinet

A. " L" Shaped Top Channel: Stick the double adhering seal to the " L" shaped top channel, and then Install the "L" shaped top channel to the cabinet as shown in (Fig. 3) using (5) 1/4" screws. B. "n" Shaped Bottom Channel installed as shown in (Fig. 3)using (4) 1/4" screws.

NOTE: For 15K to 24K models, the bottom channel has been factory- installed, and their shapes may differ from the others,but their functions are similar.

4.Assembly of the side shutters (curtains) to the cabinet.

Slide the shutters into the top and bottom channels as shown in (Fig. 4). The shutters are identified (on each frame) as "left" & "right". Attach the shutters to the cabinet using (4) 1/4" screws on each side.

Coil

Chassis

Pull Handle

Fig. 2

 

Double

 

Adhering seal

 

1/4" Screw

 

Channel

For 8K to 12K models

For 15K to 24K models

 

(Factory-installed).

Fig. 3

Shutter Frame

1/4" screw

Right Shutter

Fig. 4

9

Image 11
Contents Aire Acondicionado Para Habitaciones Room AIR ConditionerWAC 8-24 User MAN Final 3/2/05 1213 PM ´NDICE Table of ContentsPart Identification IntroductionPARTart IdentificationIDENTIFICATION Important Safety Instructions AIR Conditioner SafetyInstallation Instructions Installation RequirementsElectric Shock Hazard Electrical SpecificationsSee lists below.Fig.A Tips Before InstallationMin. Window Opening Max. Window Preparation to Remove Air Conditioner Slide-Out Chassis TOP View Installation Instructions Complete the installation Mode Operating InstructionsElectronic Control Panel Model Button Operating Instructions Cleaning the Air Filter Removal of Air Filter Care and MaintenanceProblem Possible Cause Suggested Solution Troubleshooting GuideYear Full Warranty WarrantyIntroducción IdentificaciónId tificaci n de lasdePiezaslas Piezas Peligro de Descarga El ctrica Especificaciones eléctricasPrecauci N Consejos antes de la instalaciónInstrucciones de Instalación Pida ayuda para realizar este procedimiento Precauci N Instalaci n del gabinete Finalice la instalaci n Precauci N Mbolos del indicador del panel del control Instrucciones de OperaciónBot n Mode Modo Control remoto Limpieza del Filtro de Aire Extracci n del Filtro de Aire Cuidado y MantenimientoProblema Causa Posible Soluci N Sugerida Guá para la Solución de ProblemasGarantia Completa DE 5 Anos GarantíaWAC 8-24 User MAN Final 3/2/05 1214 PM WAC 8-24 User MAN Final 3/2/05 1214 PM WAC 8-24 User MAN Final 3/2/05 1214 PM