WAC 8-24 USER MAN FINAL 3/2/05 12:13 PM Page 15
OPERATING INSTRUCTIONS
➤MechanicalMECHANICALcontrol modelCONTROL MODEL
MODE
The mode knob controls fan speeds and cooling speeds. To set desired cooling temperature, simply rotate the mode knob dial to the appropriate setting.
THERMOSTAT
The thermostat automatically controls the cooling cycle (compressor) of the air conditioner to maintain room temperature. However, the fan motor will continue to operate after the compressor (cooling cycle) is completed.
LOW FAN will circulate the air at a minimum speed without cooling.
MED FAN will circulate the air at a middle speed without cooling.
HIGH FAN will circulate the air at a maximum speed without cooling.
LOW COOL provides cooling, automatically with minimum air circulation. Recommended for night- time use.
MED COOL provides cooling, automatically with middle air circulation. Recommended for night- time use.
HIGH COOL provides cooling, automatically with quick cooling or for extremely hot days. Once room is cooled, reduce setting to LOW COOL.
OFF will completely
Fresh Air Ventilation is usually kept in the closed position. Use only when clearing smoke and/or odors from the room. Pull to open.
|
|
|
|
| OFF |
| 5 |
|
| HIGH | HIGH |
|
| 7 |
| FAN | COOL |
3 |
|
| 9 |
| 3 |
|
|
| MED | MED | |
|
|
| R | FAN | COOL |
|
|
| E |
|
|
|
|
| L |
|
|
|
|
| O |
|
|
1 |
| C | O |
| 1 |
|
|
| LOW | LOW | |
|
|
|
| FAN | COOL |
Thermostat | Mode knob |
knob |
|
Fig. 15
! CAUTION !
When using FAN control, turn slowly allowing unit to adjust.
When using THERMOSTAT, be sure to allow three minutes before changing temperature. Adjusting too quickly may cause an overload resulting in a blown fuse.
Fresh Air
Vent Lever
Fig. 16
13