Mitsubishi FR - S500 Output frequency detection, Name Factory Setting Remarks Range

2.4.2 Output frequency detection

The output frequency detection signal (FU) is output when the output frequency reaches or exceeds the setting. This function can be used for electromagnetic brake operation, open signal, etc. You can also set the detection of the frequency used exclusively for

(Hz)		Forward	Pr.42
Output frequency		rotation
				Time
			Reverse
			rotation	Pr.43
Output		ON	ON
signal
FU	OFF	OFF		OFF

reverse rotation.

This function is effective for switching the timing of electromagnetic brake operation between forward rotation (rise) and reverse rotation (fall) during vertical lift operation, etc.

Parameter	Name	Factory	Setting	Remarks
		Setting	Range
42	Output frequency	6Hz	0 to 120Hz		Setting is
	detection
					enabled
	Output frequency
			0 to 120Hz,	- - -: Same as	when Pr. 30
43	detection for reverse	- - -
			- - -	Pr. 42 setting	= "1".
	rotation

<Setting>

Refer to the above chart and set the corresponding parameters.

When Pr. 43 "output frequency detection for reverse rotation" ≠ "- - -", the Pr.42 setting applies to forward rotation and the Pr.43 setting applies to reverse rotation.

Use Pr. 64 or Pr. 65 (output terminal function selection) to assign the terminal used for FU signal output.

CAUTION

Using Pr. 64 or Pr. 65 to change terminal assignment may affect the other functions. Make setting after confirming the function of each terminal.

♦ Related parameters♦

Assignment of FU signal to terminal ⇒ Pr. 64 "RUN terminal function selection", Pr. 65 "A, B, C terminal function selection" (refer to page 90)

, Refer to , (page 62).

Refer to (page 58).

Refer to (page 59).

2

79