Mitsubishi FR - S500 Setting dial function selection, Press the RUN key to start the inverter

2.6.2 Setting dial function selection

You can use the dial like a potentiometer to perform operation.

Parameter	Name	Factory	Setting	Remarks
		Setting	Range
				0: Setting dial
				frequency setting	Setting is
	Frequency setting			mode
53		0	0, 1		enabled when
	operation selection			1: Setting dial
					Pr. 30 = "1"
				potentiometer
				mode

Using the setting dial like a potentiometer to perform operation

POINT

Set "1" (extended function parameter valid) in Pr. 30 "extended function display selection".

Set "1" (setting dial potentiometer mode) in Pr. 53 "frequency setting operation selection".

Operation example Changing the frequency from 0Hz to 60Hz during operation

OperationDisplay

1.Mode/monitor check

Choose monitor/frequency monitor. ( MODE key)

The inverter must be in the PU operation mode.

(Press the EXTPU key.)

Pr. 30 must be set to "1". Pr. 53 must be set to "1".

RUN

PU

EXT

2.	Press the RUN key to start the inverter.			RUN
			RUN	PU
				EXT
3.	Turn the setting dial	clockwise until
	"60.0" appears. The flickering frequency is			2
	the set frequency.
				Flickers for 3s.
	You need not press the	SET key.

REMARKS

•If flickering "60.0" turns to "0.0", the Pr. 53 "frequency setting operation selection" setting may not be "1".

•Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning the dial.

•When the frequency is changed, it will be stored as the set frequency often 10 seconds.

Refer to (page 82).

83