Mitsubishi FR - S500 instruction manual Extended function display selection, Frequency jump

2.3.15 Extended function display selection

Used to display the extended function parameters.

Refer to page 46 for the extended function parameter list.

Refer to the instruction manual (basic) for the parameter setting method.

Parameter		Name	Factory		Setting	Remarks
			Setting		Range
30		Extended function	0	0, 1		0: Without display,
		display selection				1: With display
2.3.16	Frequency jump		to

When it is desired to avoid	(Hz)	Pr.36		Frequency jump
resonance attributable to the
natural frequency of a mechanical	frequency	Pr.35					3A
system, these parameters allow
		Pr.34				2B
resonant frequencies to be
		Pr.33
					2A
jumped. Up to three areas may be	Running	Pr.32
set, with the jump frequencies set				1B
to either the top or bottom point of		Pr.31
			1A

each area.

The value set to 1A, 2A or 3A is a jump point and operation is performed at this frequency.

3B

Parameter	Name	Factory	Setting Range	Remarks
		Setting
31	Frequency jump 1A	- - -	0 to 120Hz, - - -
32	Frequency jump 1B	- - -	0 to 120Hz, - - -	- - -: Function invalid
33	Frequency jump 2A	- - -	0 to 120Hz, - - -
				Setting is enabled when
34	Frequency jump 2B	- - -	0 to 120Hz, - - -
				Pr. 30 = "1"
35	Frequency jump 3A	- - -	0 to 120Hz, - - -
36	Frequency jump 3B	- - -	0 to 120Hz, - - -

<Setting>

To fix the frequency at 30Hz between Pr. 33 and Pr. 34 (30Hz and 35Hz), set 30Hz in Pr. 33 and 35Hz in Pr. 34.

To jump to 35Hz between 30 and 35Hz, set 35Hz in Pr. 33 and 30Hz in Pr. 34.

CAUTION

Pr.34:35Hz Pr.33:30Hz

Pr.33:35Hz Pr.34:30Hz

During acceleration/deceleration, the running frequency within the set area is valid.

REMARKS

Write inhibit error "" occurs if the frequency jump setting ranges overlap.

72