Mitsubishi FR - S500 Handling of the RS-485 Connector, Stall prevention, Frequency jump

1.8.3 Current input selection "AU signal": Setting "4"			38
1.8.4 Start self-holding selection (STOP signal): Setting "5"			38
1.8.5 Output shut-off (MRS signal): Setting "6"			39
1.8.6 External thermal relay input: Setting "7"			39
1.8.7 Jog operation (JOG signal): Setting "9"			40
1.8.8 Reset signal: Setting "10"			40
1.8.9 PID control valid terminal: Setting "14"			41
1.8.10 PU operation/external operation switching: Setting "16"			41
1.9 Handling of the RS-485 Connector
(Type with RS-485 Communication Function)			41
1.10 Design Information			44
2. FUNCTIONS			45
2.1 Function (Parameter) List			46
2.2 List of Parameters Classified by Purpose of Use			56
2.3 Explanation of Functions (Parameters)			58
2.3.1 Torque boost	...........................................................................		58
2.3.2 Maximum and minimum frequency			59
2.3.3 Base frequency, Base frequency voltage			59
2.3.4 Multi-speed operation	to	to	....... 61
2.3.5 Acceleration/deceleration time		...................	62
2.3.6 Electronic overcurrent protection			64
2.3.7 DC injection brake	.........................................................		64
2.3.8 Starting frequency	...........................................................................		65
2.3.9 Load pattern selection	.....................................................................		66
2.3.10 Jog frequency	.......................................................................		67
2.3.11 RUN key rotation direction selection			67
2.3.12 Stall prevention function and current limit function			68
2.3.13 Stall prevention	............................................................		69
2.3.14 Acceleration/deceleration pattern			71
2.3.15 Extended function display selection			72
2.3.16 Frequency jump	to		72
2.3.17 Speed display			73
2.3.18 Biases and gains of the frequency setting voltage (current)
to	..........................................................................		74
2.3.19 Start-time ground fault detection selection			78
2.4 Output Terminal Function Parameters			78
2.4.1 Up-to-frequency sensitivity			78
2.4.2 Output frequency detection			79
2.5 Current Detection Function Parameters			80
2.5.1 Output current detection functions			80
2.5.2 Zero current detection	............................................................		81
2.6 Display Function Parameters			82
2.6.1 Monitor display	........................................................................		82
	II