Mitsubishi FR - S500 instruction manual Functions, Communication Parameters Only for the Type

2. FUNCTIONS

This chapter explains the "functions" for use of this product. For simple variable-speed operation of the inverter, the factory settings of the parameters may be used as they are. Set the necessary parameters to meet the load and operational specifications. Refer to the instruction manual (basic) for the operation procedures. Always read the instructions before using the functions.

2.1	Function (Parameter) List		46
2.2	List of Parameters Classified by Purpose of Use		56
2.3	Explanation of Functions (Parameters)		58
2.4	Output Terminal Function Parameters		78
2.5	Current Detection Function Parameters		80
2.6	Display Function Parameters		82
2.7	Restart Operation Parameters		84
2.8	Additional Function Parameters		86
2.9	Terminal Function Selection Parameters		88
2.10		Operation Selection Function Parameters	91
2.11		Auxiliary Function Parameters	109
2.12		Calibration Parameters	111
2.13		Clear Parameters	115
2.14		Communication Parameters (Only for the Type
		Having the RS-485 Communication Function)	116
2.15		Parameter Unit (FR-PU04) Setting	133

CAUTION

As the contact input terminals RL, RM, RH, STR, open collector output terminal RUN and contact output terminals A, B, C can be changed in functions by parameter setting, their signal names used for the corresponding functions are used in this chapter (with the exception of the wiring examples). Note that they are not terminal names.

REMARKS

Parameter copy

Use of the parameter unit (FR-PU04) with the type having the RS-485 communication function allows the parameter values to be copied to another inverter (only the FR-S500 series).

After batch-reading the parameters of the copy source inverter, you can connect the parameter unit to the copy destination inverter and batch-write the parameters.

For the operation procedure, refer to the instruction manual of the parameter unit (FR-PU04).

Chapter 1

Chapter2

Chapter 3

Chapter 4

45