Mitsubishi FR - S500 instruction manual Common specifications, Stf, Str

4.1.2 Common specifications

Control specifications

Control method

Output frequency range

Frequency setting resolution

Frequency accuracy

Starting torque

Acceleration/deceleration time setting

Braking		Regenerative
torque (*2)		DC braking
	Frequency	Analog input
	setting	Digital input
	signal
	Start	STF, STR
	signal
	Alarm reset
signals	Multi-speed selection
Input	Second function selection
	Output stop
	Current input selection
	External thermal relay
	input
	Jog signal
	PID control valid
	PU operation-external
	operation switching

Selectable between Soft-PWM control and high carrier frequency PWM control, V/F control or automatic torque boost control selectable.

0.5to 120Hz (starting frequency variable between 0 and 60Hz)

5VDC input: 1/500 of max. set frequency, 10V, 4 to

20mADC input: 1/1000 of max. set frequency. Digital input: 0.1Hz (less than 100Hz), 1Hz (100Hz or higher)

Analog input: Within ± 1% of max. output frequency (25ºC± 10ºC (77ºF±18ºF))

Digital input: Within ± 0.5% of set output frequency (when setting dial is used)

150% (at 6Hz) during automatic torque boost control

0, 0.1 to 999s (may be set individually for acceleration and deceleration), linear or S-pattern acceleration/deceleration mode selectable.

0.1K, 0.2K ... 150%, 0.4K, 0.75K ... 100%, 1.5K ... 50%, 2.2K, 3.7K ... 20%,

Operation frequency (0 to 120Hz), operation time (0 to 10s), operation voltage (0 to 15%)

0 to 5VDC, 0 to 10VDC, 4 to 20mA

Entered from control panel.

Forward and reverse rotation, start signal
automatic self-holding input (3-wire input) can
be selected.
Used to reset alarm output provided when
protective function is activated.
Up to 15 speeds can be selected. (Each speed
can be set between 0 and 120Hz, running
speed can be changed during operation from
the control panel.)
Used to select second functions (acceleration	Use
time, deceleration time, torque boost, base
	Pr. 60 to
frequency, electronic overcurrent protection).
	Pr. 63 for
Instantaneous shut-off of inverter output
	selection.
(frequency, voltage).
Used to select input of frequency setting signal
4 to 20mADC (terminal 4).
Thermal relay contact input for use when the
inverter is stopped by the external thermal relay.
Jog operation mode selection
Selection for exercising PID control
Used to switch between PU operation and
external operation from outside the inverter.

165