Mitsubishi FR - S500 instruction manual Speed display

2.3.17 Speed display

You can change the output frequency indication of the operation panel and parameter unit (FR-PU04) to the motor speed or machine speed.

Parameter	Name	Factory	Setting		Remarks
		Setting	Range
37	Speed display	0	0, 0.1 to 999	0: Output		Setting is enabled
				frequency		when Pr. 30 = "1".

<Setting>

To display the machine speed, set in Pr. 37 the machine speed for 60Hz operation.

CAUTION

•The motor speed is converted from the output frequency and does not match the actual speed.

•When you want to change the monitor (PU main display) of the operation panel, refer to Pr. 52 "operation panel display data selection" and communication parameter n16 "PU main display screen data selection".

•Since the operation panel indication is 3 digits, make a setting so that the monitor value does not exceed "999". If the Pr. 1 value is higher than 60Hz and

Pr. 1 value × Pr. 37 value > 60Hz × 999

(write error) occurs when Pr. 1 or Pr. 37 is written.

REMARKS

When you set the speed in Pr. 37, the speed is monitored in the monitor frequency setting mode.

At this time, setting can be made in the minimum setting increments of 0.01r/min. Due to the restrictions on the resolution of the set frequency, the indication in the second decimal place may differ from the setting.

CAUTION

Make sure that the running speed setting is correct.

Otherwise, the motor might run at extremely high speed, damaging the machine.

♦ Related parameters♦

To choose running speed monitor display ⇒ Pr. 52 "operation panel display data selection" (refer to page 82)

FR-PU04 display switching ⇒ Communication parameter n16 "PU main display screen data

selection" (refer to page 134)

2

73