Operating Instructions

WAC 8-24 USER MAN FINAL 3/2/05 12:13 PM Page 18

Operating Instructions

Remote control

How to Insert the Batteries

Remove the battery cover according to the arrow direction.

Insert new batteries making sure that the (+) and (-) of battery are matched correctly.

Reattach the cover by sliding it back into position.

Note:

Use 2 LR03 AAA (1.5volt) batteries. Do not use rechargeable batteries. Replace batteries with new ones of the same type when the display becomes dim.

If the replacement is done within 1 minute, the remote control will keep original presetting.

How to Use

To operate the room air conditioner , aim the remote control to the signal receptor. The remote control will operate the air conditioner at a distance of up to 23 feet when pointing at signal receptor of indoor unit.

Remote Control Presetting

The remote control is NOT preset as Cooling

only or Heat Pump by manufacturer.

Each time after the remote control replaces batteries or is energized, the Cooling indicatorand Heating

indicatorwill flashes alternately on LCD of the remote control.

User can preset the remote control type depending

on the air conditioner type you have purchased as follows:

Press any button when flashes, Heat Pump will be set.

Press any button when flashes, Cooling Only will be set.

Signal receptor

If you don not press any button within 12 seconds, the remote control will be set as Heat Pump

automatically.

Back-light function(optional)

Hold down any button of remote control for about 2 seconds, back-light turns on. Release the

button, it lights off automatically 10 seconds later.