Installation Instructions

WAC 8-24 USER MAN FINAL 3/2/05 12:13 PM Page 13

6.Installation of the cabinet

A.Align one hole in the bottom of the cabinet with one hole in the bracket assembly. Secure the cabinet to the bracket using (3) 1/4" screws provided. Repeat the same procedure on the opposite side of the cabinet. See (Fig. 10).

B.Ensure the "L" shaped mounting channel is positioned in front of the sash. The "U" shaped bottom channel of the cabinet should be positioned in the track provided on the bracket assembly. Pull the window down until it rests just behind the front of the "L" shaped mounting channel. See (Fig. 11).

C.Check to make sure that the cabinet is slanted slightly downward on the outside. If necessary, re-adjust support bracket as shown in (Fig. 7).

7.Secure Shutters

A.Carefully slide the air conditioner back into the

cabinet.(Please seek assistance for this procedure).

B.Reinstall the slide-out-chassis security screws (removed earlier) on both sides of the cabinet. See (Fig. 12).

Secure the top of the frames to the window sash with

(2) 3/4" screws.

C. Now, secure bottom frame of shutters using one shutter clamp and one 3/4" screw on each side(Fig. 12).

8. Reinstalling Front Panel Assembly

A. Position the front panel on the cabinet starting at the top. The front panel lock tabs must be inserted into the

1/4" Screws

Fig. 10

Window Sash

"L"Shaped Seal

Mounting

Channel

Fig. 11

3/4" screws

"L"Shaped Seal

Mounting

Channel

retaining slots in the cabinet. Repeat this procedure on all sides.

Coil

Security Screw

B. Secure the front grille to the cabinet using the Philips screws removed earlier(Fig. 1).

Fig. 12