|
| MicroDock II | |
|
| Charger Specifications | |
Charger Specifications | This equipment generates, uses, and can radiate radio fre- | ||
Size: 8.6 x 8.2 x 7.8 cm (3.4 x 3.2 x 3.1 in.) | quency energy and, if not installed and used in accordance with | ||
the instruction manual, may cause harmful interference to radio | |||
Weight: 97 g (3.4 oz.) per model | |||
communications. | |||
Charger system ingress protection: IP20 | |||
Operation of this equipment in a residential area is likely to | |||
Operating temperature: 10°C to 35°C (50°F to 95°F) | |||
cause harmful interference in which case the user will be | |||
Humidity: 0 to 50% | |||
required to correct the interference at his/her own expense. | |||
Altitude: 2000 m (6561.66 ft.) | |||
| |||
Power: 6 Vdc , 2.5 A | a Warning | ||
Charging LED: | This product is designed for installation in an indoor | ||
complete, and charger fault | location only. All required National Electrical Codes and | ||
Charge time: Typically | Safety Standards must be followed. | ||
Pollution Degree: 2 | For ac main installation, a circuit breaker should be | ||
Installation Category: I | |||
included in the building installation as a disconnect | |||
This device complies with the FCC Part 15 and | device for the equipment. The disconnect device should | ||
Canadian EMI requirements. Operation is subject to the follow- | be installed in close proximity to the equipment and the | ||
ing two conditions: | device should be marked as a disconnecting means for | ||
1. | This device may not cause harmful interference, and | the equipment. | |
| |||
2. | this device must accept any interference received, |
| |
| including interference that may cause undesired |
| |
| operation. |
| |
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules and
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
15