MicroDock II
Quick Reference Guide
Inserting the Detector | station LCD displays the docking module number, and | ||
| a Caution | the type and serial number of the detector. | |
| GasAlertMicro | ||
Infrared or intense ambient light (sun or halogen) may | |||
• Insert the bottom of the detector (serial number face up) | |||
interfere with the base station/detector communication. | |||
To insert a detector into a docking module, complete the follow- | into the detector bay first and then lower the top into | ||
place. | |||
ing: |
| ||
| • Close the lid and press until the release tabs click. | ||
1. | Activate the detector and wait until it is in normal | ||
• When the detector has been inserted correctly, the RUN | |||
| operation. | ||
| LED(s) on the docking module light yellow and Unit | ||
|
| ||
2. Ensure the alligator clip is closed and the ring is rest- | Inserted displays on the base station LCD. The base | ||
| ing flat on the detector. | station LCD displays the docking module number, and | |
3. | Press the two release tabs on the docking module | the type and serial number of the detector . | |
GasAlertMicro 5/PID/IR | |||
| and open the lid. | ||
•If inserting the GasAlertMax XT, move the pump Important: If the GasAlertMicro 5/PID/IR detector is fitted with
connector to the open position (red). | a pump module, the diffusion adapter must be removed from | |
4. Refer to the following sections to insert the detectors | the docking module. Refer to the MicroDock II Base Station | |
into the docking modules. | User Manual. | |
GasAlertClip Extreme / GasAlert Extreme | • Insert the GasAlertMicro 5/PID/IR (LCD facing up) at a | |
• Lower the detector (serial number face up) into the | 45° angle and insert the bottom into the docking bay. | |
Ensure the connector outlets on the bottom of the detec- | ||
detector bay. | ||
tor lock into place over the connector pins in the docking | ||
• Push forward to ensure the top of the detector connects | bay. | |
with the top of the bay. | • Close the lid and press until the release tabs click. |
•Close the lid and press until the release tabs click.
•When the detector has been inserted correctly, the RUN LED(s) on the docking module light yellow and Unit Inserted displays on the base station LCD. The base
6