KitchenAid W10117506B Installation Requirements, Tools and Parts, Product Dimensions

Page 5

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Product Dimensions

A

Tools Needed

■Tape measure

■Small, flat-blade screwdriver

■Flat-blade screwdriver

■#2 and #3 Phillips screwdriver

■Level

■Wrench or pliers

■Pipe wrench

■Scissors or cutting pliers (to remove tiedowns)

■Noncorrosive leak detection solution

Parts Needed

■Gas line shutoff valve

■½" male pipe thread nipple for connection to pressure regulator

■LP gas-resistant pipe-joint compound

■CSA design-certified outdoor flexible stainless steel appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply line as needed.

Parts Supplied

■Convertible regulator set for 4" WCP Natural gas.

■Single-prong plug/5,000 mAmp transformer assembly

Location Requirements

Select a location that provides minimum exposure to wind and traffic paths. The location should be away from strong draft areas.

Do not obstruct flow of combustion and ventilation air.

Clearance to combustible construction for built-in outdoor sear burners:

■A minimum of 24" (58 cm) must be maintained between the sides and back and any combustible construction.

■A 24" (58 cm) minimum clearance must also be maintained below the cooking surface and any combustible construction.

Ignition

A grounded, 3-prong outdoor outlet located to the left of the sear burner is required. See “Electrical Requirements” section.

B

C

D

E

F

G

 

 

 

 

 

 

 

 

 

 

 

H

 

 

 

 

 

 

 

A. 13"

(33 cm)

 

E. 25³⁄₈" (64.5 cm)

B. 12³⁄₄" (32.4 cm)

 

F. Manifold pipe

C. 17"

(43.2 cm)

 

G. 2¹⁄₂" (6.4 cm)

D. 26³⁄₈" (67 cm)

 

H. 22³⁄₄" (57.8 cm)

Built-In Outdoor Sear Burner Enclosure

The enclosure for the built-in outdoor sear burner is to be a minimum of 11" (28.0 cm) high x 23" (58.4 cm) deep x 14" (35.6 cm) wide.

Cabinet Dimensions

Enclosure and clearance dimensions that are shown must be used. Given dimensions provide required clearances.

Counter or support surfaces must be level.

The installation of this sear burner must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NPFA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2.

Copies of the standards listed may be obtained from: CSA International

8501 East Pleasant Valley Rd.

Cleveland, Ohio 44131-5575

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Outdoor BUILT-IN Sear Burner Table DES Matières Table of ContentsYour safety and the safety of others are very important Outdoor BUILT-IN Sear Burner SafetyImportant Safety Instructions Product Dimensions Installation RequirementsCabinet Dimensions Tools and PartsRecommended Ground Method Electrical RequirementsGas Supply Requirements Outdoor Sear Burner Installation Installation InstructionsMake Gas Connection Natural Gas Use Plug in Sear BurnerLightingthe Infrared Sear Burner Check and Adjust the BurnersOutdoor Sear Burner USE Outdoor Sear Burner Care General CleaningManually Lighting Infrared Sear Burners Stainless SteelTroubleshooting Kitchenaid Outdoor Product Warranty Assistance or ServiceAccessories U.S.ADisclaimer of Implied Warranties Limitation of Remedies Items Excluded from WarrantyThis limited warranty does not cover Votre sécurité et celle des autres est très importante Sécurité DU Brûleur À Infrarouge Encastré DextérieurConservez CES Instructions Dimensions du produit Exigences DinstallationExigences demplacement Dimensions du placardSpécifications électriques Méthode recommandée de mise à la terrePuissance thermique des brûleurs en altitude Spécifications de lalimentation en gazTest de pressurisation de la canalisation de gaz Gaz naturelRaccordement au gaz Alimentation au gaz naturel Instructions DinstallationInstallation du brûleur à infrarouge Dextérieur Allumage du brûleur à infrarouge Utilisation DU BrûleurContrôle et réglage des brûleurs Nettoyage général Utilisation du brûleur à infrarougeBouteille de propane de 20 lb après conversion Allumage manuel des brûleurs à infrarougeAcier Inoxydable Illustrations DU Tableau DE CommandeExtérieur IntérieurAccessoires Assistance OU ServiceDépannage Garantie DES Produits Pour Usage Extérieur KitchenaidW10117506B Articles Exclus DE LA GarantieLa présente garantie limitée ne couvre pas

W10117506B specifications

The KitchenAid W10117506B is a versatile and innovative appliance that has quickly become a favorite among both professional chefs and home cooks. Designed to enhance the culinary experience, this kitchen gadget boasts a range of features, technologies, and characteristics that set it apart from its competitors.

One of the standout features of the KitchenAid W10117506B is its powerful motor. The appliance is equipped with a robust motor that allows for seamless mixing and blending, making it easy to whip up dough, batter, and various ingredients in no time. This powerful motor ensures consistent results, reducing the effort and time needed for food preparation.

The design of the W10117506B is both ergonomic and aesthetically pleasing. Its sleek lines and polished finish will complement any kitchen décor, while the compact size allows for easy storage. The user-friendly interface includes intuitive controls that make it simple to adjust speeds and settings, offering full control over the mixing process.

Another key technology in the KitchenAid W10117506B is its planetary mixing action. This innovative design rotates the mixing attachment around the bowl while also spinning around its axis, ensuring that all ingredients are thoroughly incorporated. This feature is particularly useful for achieving perfectly blended mixtures without the dreaded lumps or clumps that can occur with less advanced appliances.

In addition to its mixing capabilities, the W10117506B offers several attachments that enhance its functionality. These attachments allow users to perform a variety of tasks, such as kneading dough, shredding vegetables, or even making pasta. The versatility of this appliance makes it a valuable addition to any kitchen.

The construction of the KitchenAid W10117506B also deserves mention. Built from high-quality materials, it is designed for durability and longevity. This means that users can rely on it for years of dependable service without worrying about wear and tear.

In conclusion, the KitchenAid W10117506B is a must-have for anyone who spends time in the kitchen. Its powerful motor, ergonomic design, innovative mixing technology, versatile attachments, and durable construction make it an indispensable tool for culinary enthusiasts. Whether you are baking, whipping, or mixing, this appliance is sure to elevate your cooking experience to new heights.
Top Page Image Contents