INSTALLATION INSTRUCTIONS
Outdoor Sear Burner Installation
WARNING
Excessive Weight Hazard
Use two or more people to move and install
Failure to do so can result in back or other injury.
■Unpack sear burner. Remove all packaging materials and remove sear burner from carton.
■Move sear burner close to desired outdoor location.
Make Gas Connection
Natural Gas Use
This installation must conform with local codes and ordinances. In the absence of local codes, installations must conform with either the National Fuel Gas Code ANSI Z223.1 - latest edition, or
3.Using a wrench to tighten, connect the gas supply to the sear burner. Use
A
B
DC
A. ½" (1,3 cm) sear burner gas pipe
B. New CSA International approved “outdoor” flexible gas supply line
C. Rear of sear burner
1.Place sear burner into outdoor enclosure, but leave enough room in back to connect to gas supply and plug in electrical
WARNING
Explosion Hazard
Use a new CSA International approved “outdoor” gas supply line.
Securely tighten all gas connections.
Failure to do so can result in death, explosion, or fire.
2.A combination of pipe fittings must be used to connect the sear burner to the existing gas line. If local codes permit, use an outdoor flexible stainless steel tubing gas connector,
D. To Natural gas supply
4.Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.
A
B
A. Closed valve
B. Open valve
5.Test all connections by brushing on an approved noncorrosive
Plug in Sear Burner
1.This
A
A.
†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
8