Insert burner
yPosition the burner in the front of the appliance and loosely tighten the nuts on the mounting studs. The burner should be pitched downward 2° as shown in Figures 4 and 8.
ySee Figure 8. Install the pedestal support kit (recommended) by attaching the 3/4” npt flange (item a) to the bottom of the burner using the (4) #10 screws provided. Cut and thread (one end only) a 3/4” pipe nipple (item b) with length 11 inches less than dimension D in Figure 8. Thread the pipe into the flange. Then slip the pipe end into the floor flange (item c).
ySecure the burner to the appliance by tightening the nuts on the burner flange mounting studs. Then secure the pedestal support floor flange set screw to the pipe.
Figure 8 – Burner installed in appliance front
Legend
HHousing total length
JCenter to bottom of housing
KOverall housing height
Dimension | CF 1400 | CF 2300 |
H | 18” | |
J | ||
K |
Form 6104 | 11 |
|