InFocus W59, QR80421 manual connect monitor cable connect RS-232cable, connect CAT-5cable, Network

Page 10

connect monitor cable

If you are using a desktop computer and want to see the image on your computer screen as well as on the projection screen, plug the monitor cable to the Monitor out connector on the projector.

You can control the projector from an LCD control panel, touch screen, or other control device or computer by connecting an RS-232 cable to the pro- jector’s Serial Control connector. Specific RS-232 commands can be found in the Service and Support section of our website and in the Appendix.

The projector can be managed by networking software through its Network (RJ-45) connector. Detailed instructions on this feature can be found on our website.

connect monitor cable

connect RS-232 cable

connect CAT-5 cable

Network

9

Image 10

Contents Regulatory models W59 IN5110 User’s Guide5100 QR80421FCC Warning Remote Control WarningDeclaration of Conformity EN 55022 WarningPage Table of Contents Important Operating Considerations for Safety 0.6 mIntroduction Included ItemsConnector Panel Positioning the projector Projection angle in 16 10 mode defaultConnecting a computer Required computer connectionsconnect CAT-5cable connect monitor cable connect RS-232cableNetwork Displaying a computer image ? No computer image? Get help on pageAdjusting the image Standard video connections Connecting a video deviceOptional video connections Displaying a video image Adjust the volume in the Audio menu Power Save Troubleshooting your setupShutting down the projector Status Indicator Panel iconsSolution startup screenProblem No startup screen Plug power cable in, press power switch andSet your computer’s display resolution to the resolution on your computer, as shownin the following problem, “Image fuzzy native resolution of the projectorSolution Projector troubleshootingProblem Adjust keystone in the Picture menuCOLOR Turn on/off Ceiling in Settings System menuTurn on/off Rear in Settings System menu COLORLamp won’t turn on, Temp light is lit page startup screenstartup screen Lamp won’t turn on, Lamp light is lit pageImage not centered on screen Still having problems?Correct image Using the keypad buttons Using the remote control Troubleshooting the remoteTroubleshooting audio Using the audioConnecting external speakers Presentation features Optimizing computer imagesOptimizing video images Customizing the projectorUsing the menus Picture menu Advanced settings tings Service menuComputer Video Standard Active IrisComputer Table 2 Split Screen Matrix Split Screen Menu Sources Settings menuAudio SourceCapture New Screen SaveStartup Logo Blank ScreenBlank shows an empty screen Service Info provides information for service Maintenance Cleaning the lensReplacing the projection lamp WARNINGSloosen the captive screws on lamp module reset lamp hours in Service menulamp module handle reset filter hours in Service menu security lock Cleaning the dust filterUsing the security lock wait 45 minutes dust filter cover tabsAppendix Projected image sizeRead Command Examples Command ControlRS-232Port Settings SettingDefault Write Command ExamplesCommand FunctionAuto Image Corner Correction Horizontal Position Magnify Reset Lamp Hours Source Vertical Position H HDMI INDEXNumerics I image