InFocus W59, QR80421 manual Write Command Examples, Function, Response, Default, Step

Write Command Examples

Function	Command	Response
Brightness	(BRT100)	Sets the brightness to 100
Power	(PWR0)	Turns power off
Power	(PWR1)	Turns power on

Error Conditions

Not all commands are supported for all projectors. If an unsupported com- mand is issued, the command will be ignored. If a command is received that is not understood, a ‘?’ character will be returned indicating the command was not understood.

Limitations

The projector cannot respond to commands coming in at a high-rate. There- fore, a delay must occur between commands to ensure that the command gets properly executed.

The Step column refers to increasing or decreasing the menu bar position since the On-screen Display is not an exact match of values. For example, Step 2 changes the data by 2 through the CLI (Command Line Interface). The menu bar is up (or down) by 1.

Function	Com	RW	Min	Max	Default	Step
	mand
Active Iris*	IRI	RW	0	2	1	1
0: Off
1: Presentation
2: Film
AMX Device Discov-	AMX	RW	0	1	0	1
ery Enable
0: Disable; 1: Enable
Aspect Ratio	ARZ	RW	0	6	0	1
0: Auto
1: Native
2: 4:3
3: 16:9
6: 16:10
Aspect Ratio (Split	ARL	RW	0	6	0	1
Screen left)
0: Auto
1: Native
2: 4:3
3: 16:9
6: 16:10
Aspect Ratio (Split	ARR	RW	0	6	0	1
Screen right)
0: Auto
1: Native
2: 4:3
3: 16:9
6: 16:10

43