InFocus W59, QR80421 manual loosen the captive screws on lamp module, lamp module handle

Page 40

loosen the captive screws on lamp module

4Loosen the three captive screws (marked by the arrows) on the lamp module. When replacing the lamp, never touch any screws without the arrow mark.

5Carefully remove the lamp module by grasping and lifting the handle. Dispose of the lamp in an environmentally proper manner.

6Install the new lamp module, making sure that it is properly seated, and tighten the three captive screws.

7Replace the cover over the lamp module by sliding it back into place and tightening the screw.

8Plug in the power cable, press the power switch then press the Power button to turn the projector back on. Reset the lamp hour timer by navi- gating to the Settings>Service menu and selecting Reset Lamp Hours.

loosen the captive screws on lamp module

lamp module handle

reset lamp hours in Service menu

39

Image 40

Contents IN5110 User’s Guide 5100Regulatory models W59 QR80421Remote Control Warning Declaration of ConformityFCC Warning EN 55022 WarningPage Table of Contents Important Operating Considerations for Safety 0.6 mIntroduction Included ItemsConnector Panel Positioning the projector Projection angle in 16 10 mode defaultConnecting a computer Required computer connectionsconnect CAT-5cable connect monitor cable connect RS-232cableNetwork Displaying a computer image ? No computer image? Get help on pageAdjusting the image Standard video connections Connecting a video deviceOptional video connections Displaying a video image Adjust the volume in the Audio menu Troubleshooting your setup Shutting down the projectorPower Save Status Indicator Panel iconsstartup screen Problem No startup screenSolution Plug power cable in, press power switch andresolution on your computer, as shown in the following problem, “Image fuzzySet your computer’s display resolution to the native resolution of the projectorProjector troubleshooting ProblemSolution Adjust keystone in the Picture menuTurn on/off Ceiling in Settings System menu Turn on/off Rear in Settings System menuCOLOR COLORstartup screen startup screenLamp won’t turn on, Temp light is lit page Lamp won’t turn on, Lamp light is lit pageImage not centered on screen Still having problems?Correct image Using the keypad buttons Using the remote control Troubleshooting the remoteTroubleshooting audio Using the audioConnecting external speakers Presentation features Optimizing computer imagesOptimizing video images Customizing the projectorUsing the menus Picture menu Advanced settings tings Service menuComputer Video Standard Active IrisComputer Table 2 Split Screen Matrix Split Screen Menu Settings menu AudioSources SourceScreen Save Startup LogoCapture New Blank ScreenBlank shows an empty screen Service Info provides information for service Maintenance Cleaning the lensReplacing the projection lamp WARNINGSloosen the captive screws on lamp module reset lamp hours in Service menulamp module handle Cleaning the dust filter Using the security lockreset filter hours in Service menu security lock wait 45 minutes dust filter cover tabsAppendix Projected image sizeCommand Control RS-232Port SettingsRead Command Examples SettingWrite Command Examples CommandDefault FunctionAuto Image Corner Correction Horizontal Position Magnify Reset Lamp Hours Source Vertical Position INDEX NumericsH HDMI I image