InFocus W59 Declaration of Conformity, FCC Warning, EN 55022 Warning, EN EMC directive, Canada

Page 2

Declaration of Conformity

Manufacturer: InFocus Corporation, 13190 SW 68th Parkway, Suite 200, Portland, Oregon 97223 USA

We declare under our sole responsibility that this projector conform to the following directives and norms:

EMC Directive 2004/108/EC EMC: EN 55022

EN 55024

EN 61000-3-2

EN 61000-3-3

Low Voltage Directive 2006/95/EC Safety: IEC 60950-1: 1st Edition

Trademarks

Apple, Macintosh, and PowerBook are trademarks or registered trademarks of Apple Computer, Inc. IBM is a trademark or registered trademark of International Business Machines, Inc. Microsoft, PowerPoint, and Windows are trademarks or registered trademarks of Microsoft Corporation. Adobe and Acrobat are trademarks or registered trademarks of Adobe Systems Incorporated. HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC. InFocus, In Focus, and INFOCUS (stylized) are either registered trademarks or trademarks of InFocus Corporation in the United States and other countries.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interferences received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by InFocus Corporation may void authority to operate the equipment.

EN 55022 Warning

This is a Class A product. In a domestic environment it may cause radio interference, in which case the user may be required to take adequate measures. The typical use is in a conference room, meeting room or auditorium.

EN EMC directive

This product may cause interference if used in residential areas. Such use must be avoided unless the user takes special measures to reduce electromagnetic emissions to prevent interference to the reception of radio and television broadcasts.

Canada

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

Agency Approvals

UL, CUL

Other specific Country Approvals may apply, please see product certification label.

InFocus reserves the right to alter product offerings and specifications at any time without notice.

This document applies to model W59.

Input ratings: 100-120/220-240Vac, 5.0/2.1A, 50/60Hz

Remote Control Warning

Laser radiation class II product; wavelength 650nm; maximum output 1mW. Remote control complies with applicable requirements of 21 CFR 1040.10 and 1040.11. Remote control complies with applicable requirements of IEC60825-1:1993 +A1:1997 +A2: 2001 or IEC60825-1:2007 EN60825-1:2007.

1

Image 2
Contents Regulatory models W59 IN5110 User’s Guide5100 QR80421FCC Warning Remote Control WarningDeclaration of Conformity EN 55022 WarningPage Table of Contents Important Operating Considerations for Safety 0.6 mIntroduction Included ItemsConnector Panel Positioning the projector Projection angle in 16 10 mode defaultConnecting a computer Required computer connectionsNetwork connect monitor cable connect RS-232cableconnect CAT-5cable Displaying a computer image ? No computer image? Get help on pageAdjusting the image Optional video connections Connecting a video deviceStandard video connections Displaying a video image Adjust the volume in the Audio menu Power Save Troubleshooting your setupShutting down the projector Status Indicator Panel iconsSolution startup screenProblem No startup screen Plug power cable in, press power switch andSet your computer’s display resolution to the resolution on your computer, as shownin the following problem, “Image fuzzy native resolution of the projectorSolution Projector troubleshootingProblem Adjust keystone in the Picture menuCOLOR Turn on/off Ceiling in Settings System menuTurn on/off Rear in Settings System menu COLORLamp won’t turn on, Temp light is lit page startup screenstartup screen Lamp won’t turn on, Lamp light is lit pageCorrect image Still having problems?Image not centered on screen Using the keypad buttons Using the remote control Troubleshooting the remoteConnecting external speakers Using the audioTroubleshooting audio Presentation features Optimizing computer imagesOptimizing video images Customizing the projectorUsing the menus Picture menu Advanced settings tings Service menuComputer Video Standard Active IrisComputer Table 2 Split Screen Matrix Split Screen Menu Sources Settings menuAudio SourceCapture New Screen SaveStartup Logo Blank ScreenBlank shows an empty screen Service Info provides information for service Maintenance Cleaning the lensReplacing the projection lamp WARNINGSlamp module handle reset lamp hours in Service menuloosen the captive screws on lamp module reset filter hours in Service menu security lock Cleaning the dust filterUsing the security lock wait 45 minutes dust filter cover tabsAppendix Projected image sizeRead Command Examples Command ControlRS-232Port Settings SettingDefault Write Command ExamplesCommand FunctionAuto Image Corner Correction Horizontal Position Magnify Reset Lamp Hours Source Vertical Position H HDMI INDEXNumerics I image