Desa BCLP375, RCLP375 owner manual Check all connections for leaks

INSTALLATION

Continued

3.Connect hose to inlet connector. Tighten firmly using a wrench. IMPORTANT: Use extra hose or piping if needed. Install extra hose or piping

between hose/regulator assembly and propane tank. You must use the regula- tor supplied with heater.

Inlet Connector Hose

Figure 4 - Hose and Inlet Connector

4.Open propane supply valve on propane tank(s) slowly. Note: If not opened slowly, excess-flow check valve on propane tank will stop gas flow. If this happens, close propane supply valve and open again slowly.

5.Adjust regulator between 48 and 138 kPa (7 and 20 psig) (see Figure 5). Note: Higher regulator setting will allow heater to produce more heat.

WARNING

WARNING ICON G 001

Do not adjust regulator below 48 kPa (7 psig) or above 138 kPa (20 psig). Heater may not run properly.

		I
		N
			C
				R
			A	E
		E S
5
10
15
	5		5
20	10		10
	15		15
	20		20

Regulator

Figure 5 - Adjustable Regulator Set At 48 kPa (7 psig)

6. Check all connections for leaks.

WARNING

WARNING ICON G 001

Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all leaks at once.

7. Close propane supply valve. 7

100165