Desa CB36N Manual Lighting Procedure, Electronic Ignition System Lighting Instructions, Rod

Manual Lighting

Procedure

1.Remove glass door (see Removing/Re- placing Glass Door, page 18).

2.Follow steps 1 through 8 under Lighting Instructions, page 20).

3.Press gas control knob and light pilot with match.

4.Keep gas control knob pressed in for 30 seconds after lighting pilot. After 30 sec- onds, release gas control knob. Follow steps 10 through 11 under Lighting Instruc- tions, page 20).

5.Replace glass door (see Removing/Re- placing Glass Door, page 18).

Electronic Ignition

System

lighting

instructions

1.STOP! Read the safety information, page 20.

2.Turn off all electrical power to the fire- place.

3.Turn wall switch to the OFF position.

4.Open lower louver panel.

5.Turn equipment shutoff valve clockwise to the OFF position (see Figure 34). Do not force.

6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information, page 20. If you don’t smell gas go to the next step.

7.Turn equipment shutoff valve counter-

clockwise to the ON position. Do not force.

11.Visually locate pilot. Ignitor should begin to spark and main burner should ignite once flame appears at pilot.

•If lighting appliance for the first time each season, it may take several attempts before supply gas can reach pilot and main burner.

•If appliance will not stay lit after several attempts, follow instructions in To Turn Off Gas To Appliance, and call your service technician or gas supplier.

NOTICE: During initial operation of a new heater, the burning of residues from the manufacturing process of the firebox and logs willproduceapaper-burningsmell andorangeflames.Openawindow for the first few hours of operation to adequately vent this smell.

TO TURN OFF GAS

TO APPLIANCE

1.Turn off wall switch.

2.Turn off all electric power to appliance if service is to be performed.

3.Open lower louver panel.

4.Turn equipment shutoff valve clockwise to OFF. Do not force.

5.Close lower louver panel.

8.Close lower louver panel.

9.Turn on all electric power to fireplace.

10.Turn wall switch to the ON position.

Figure 34 - Turning Equipment Shutoff

Valve to the OFF Position

Figure 35 - Pilot

OPTIONAL WIRELESS

REMOTE OPERATION

Note: The WRC receiver and hand-held remote control kit must be purchased sepa- rately (see Accessories, page 31). Follow installation instructions included with the remote control.

1.Turn equipment shutoff valve to ON posi- tion. You can now turn burner on and off with hand-held remote unit.