Fireplace Installation
Continued
INSTALLING LOGS AND GLOWING EMBERS
A 4 piece ceramic log set comes packed in- side the unit firebox. Removal of glass door is necessary to unpack and assemble logs and add hearth treatments. Follow steps under Removing/Replacing Glass Door, page 18 to access logs and burner.
Assemble logs and add burner treatments as follows:
1.Position base log onto burner log mounts (see Figure 31).
Note: Cut out on bottom should fit over mounts and base log should be positioned against rear panel.
2. | Position holes on bottom of rear log over |
| pins on base log (see Figure 31). |
3. | Position top left log and top right log |
| onto rear log and base log as shown in |
| Figure 31. |
4. | Break ember material into quarter sized |
| pieces and place a single layer along the |
| full length of ember tray to hide bottom |
| edge of base log (see Figure 32). |
5. | Replace glass door and louver panels |
Top Left Log 
Rear 
Log
Burner
Base Log
Top
Right
Log
(see Removing/Replacing Glass Door, |
page 18). |
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
Rear Log
Stand
Log
Mounts
Burner
Pan
Figure 31 - Installing Logs
Ember
Tray
Ember
Material
Figure 32 - Applying Ember Material
www.desatech.com | 19 |