B.2 MODEL 24SII MEMORY MODULE INSTALLATION
Each memory module provided by BayTech includes one of the following modules: M24SII-M01 (0 to 4MB) or M24SII-M02 (0 to 16MB).
You will need the following equipment:
1x phillips-head screwdriver
1x 3/8 in. nut driver or socket
1.IMPORTANT: Remove power from the unit by depressing the power switch on the front of the unit to OFF and also remove power cord from socket.
2.Using the phillips-head screwdriver, remove the 4 phillips-head screws holding the top cover of the unit. After screws are removed, lift off cover.
3.Determine which type of memory module you are installing. The 4MB memory module (part no. M24SII-M01) allows you to upgrade the total memory to 4MB using 1MB zig zag in-line packages (ZIPs). The 16MB memory module (part no. M24SII- M02) provides buffer expansion up to 16MB using either 1MB x
8or 4MB x 8 single in-line memory modules (SIMMs).
4.Determine the location where the new memory module will install into. Refer to Appendix D.2. This mechanical layout shows the location where the M24SII-M01 memory module installs into which is marked 11. If you are installing the M24SII-M02 memory module, the location where it installs into is adjacent to the location shown for the M24SII-M01 and is notmarked on the drawing.
