A.7 MODULAR CABLING USING M24SII-V07
I/O MODULE
A.7.1 RJ-45 (8-WIRE) CABLING
NOTE: If you have configured a port on the M24SII-V07 I/O module to use EIA-232 Protocol and 8-wire Operation, please refer to Appendix A.5 for recommended adapter/cabling information.
If you have configured a port on the M24SII-V07 module to use EIA- 422 Protocol, 8-wire Operation, and you are not connecting this port to another BayTech product, please see Figure 9 in Section 5.5.1 for a recommended cabling diagram.
If you are connecting another BayTech device (such as Tran-x) to a port on the M24SII-V07 module as described, an RJ-45 crossed cable is required to connect the two devices as shown in Figure 18 below.
RJ-45 | RJ-45 |
PIN | PIN |
1 | 1 |
2 | 2 |
3 | 3 |
4 | 4 |
5 | 5 |
6 | 6 |
7 | 7 |
8 | 8 |
Figure18++(23(#(*#("!1$- | |
NOTE: Before connecting a Tran-x device to the M24SII-V07 module
using this configuration, you must make sure the Tran-x has been configured to use 8-wire Operation. Please see the Tran-x Operator's Manual for instructions.
