HP manual M24SII-M02 Buffer Expansion Simm Installation

C.2 M24SII-M02 BUFFER EXPANSION SIMM INSTALLATION

Each memory expansion upgrade kit provided by BayTech includes either a 1MB x 8 or 4MB x 8 SIMM (single in-line memory module). You may also use third party SIMMs. The total buffer size may range from 0MB to 16MB with a minimum of 1MB required for operation. Please use the following instructions when installing memory expansion SIMMs.

You will need a phillips-head screwdriver.

1.IMPORTANT: Remove power from the unit by depressing the power switch on the front of the unit to OFF. Also remove power cord from socket.

2.Using the phillips-head screwdriver, remove the four

phillips-head screws holding the top cover of the unit. After screws are removed, lift off cover.

3.With LED side of the unit facing you, look down into the unit and locate the memory board. The memory board has four sockets for memory expansion. These straight-line sockets are marked U15, U16, U17 and U18 (refer to Appendix D.5 - M24SII-M02 Memory Board Assembly). Note that one or more of these sockets may already have a memory module installed.

4.U15 must always be occupied by either a 1MB or 4MB SIMM. Any new memory expansion module(s) may be installed in any of the remaining sockets (i.e., U16, U17, or U18) and need not be installed in any specific order.

￿￿￿