&￿￿ ￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

NOTE: This section does not pertain to the M24SII-V02 high speed parallel module.

OPTION ACCESSIBILITY: Through Port 1 of Module 1 only.

By responding to the Enter Request: message at the end of the main configuration menu (see Section 8.1) with "3" (Set Port Designation), you may designate any port on the selected module as a computer port or a printer port.

Plotters should be connected to ports designated as printer ports. Modems should be connected to ports designated as computer ports. A minimum of one port per Model 24SII DES unit must always be designated as a computer port. If Module 1 is occupied by an M24SII-V03, M24SII-V04, M24SII-V06A, M24SII-V07, or M24SII-V08 high speed serial module, Port 1 of Module 1 cannot be configured to be a printer port.

The Model 24SII DES will respond with:

Enter Request :3

--------------------------------------------------

Port

Logical Name

Port

Port

Prnt

 

Type

Desig

Assn

--------------------------------------------------

1

Device A

Serial Computer

0

2

Device B

Serial Printer

1-2

3

Device

C

Serial

Computer

0

4

Device

D

Serial

Computer

0

--------------------------------------------------

Enter Port Number (ENTER=Exit) :

Enter the number of the port that you wish to designate a computer port or a printer port and then strike the Enter key. For example, if you entered "4" and Enter for Port 4, the Model 24SII DES will respond with:

Port Is Assigned as a ( Computer) Port

Enter P or C to Change, Enter When Done :

You may now designate the port by entering "P" for printer port or "C" for computer port. Enter may be sent for no change. For example, if you entered "P", the Model 24SII DES will respond with:

￿￿

Port is designated as a ( Printer ) Port