HP manual Model 24SII Memory Module Eprom Upgrade

C.4 MODEL 24SII MEMORY MODULE EPROM UPGRADE

The materials you will receive with your upgrade kit are:

1 EPROM (chip with label). This Chip will be marked to identify which memory module type they install into.

The materials you will need to supply are: Phillips-head screwdriver

IC DIP extractor or a pair of curved needle-nose pliers

1.IMPORTANT: Remove power from the unit by depressing the power switch on the front of the unit to OFF. Also remove power cord from the AC outlet.

2.Using the phillips-head screwdriver, remove the 4 phillips-head screws holding the top cover of the unit. After screws are removed, lift off cover.

3.If upgrading the M24SII-M01 memory module, locate socket U102 on the module (see Appendix D.4). If upgrading the M24SII-M02 memory module, locate socket U2 on the module (see Appendix D.5).

4.Remove existing EPROM from the appropriate socket with IC extractor or needle-nose pliers. Gradually loosen each side of the chip, alternating pliers from side to side, so as not to bend chip pins. Pull loosened EPROM all the way out.

5.

￿￿￿6.

Install new EPROM into the appropriate socket. The EPROM is notched; the notch on the EPROM should line up with the notch on the socket. When installing the new chip, be careful not to bend any of the pins. Make sure none of the pins miss their socket. Also make certain that you install the correct EPROM into the appropriate memory module.

Replace the cover; the upgrade is now complete.